• Home
• Brands
• Cisco Manuals
• Cisco Aironet 350 Series
• Cisco AIR-BR350-A-K9 - Aironet 350 Wireless Bridge Installation Manual

Cisco AIR-BR350-A-K9 - Aironet 350 Wireless Bridge Installation Manual

Download Hardware installation manual of Cisco Aironet 350 Series Adapter, Computer Hardware for Free or View it Online on All-Guides.com. This version of Cisco Aironet 350 Series Manual compatible with such list of devices, as: Aironet 350 Series, AIR-BR350-A-K9 - Aironet 350 Wireless Bridge, AIR-BR350-E-K9, AIR-BR350-E-K9-RF - Aironet 350 - Wireless Bridge, AIR-PCI352

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

30

31

32

33

34

35

36

37

38

39

40

41

42

43

44

45

46

47

48

49

50

51

52

53

54

55

56

57

58

59

60

61

62

63

64

65

66

67

68

69

70

71

72

73

74

75

76

2-8

Cisco Aironet 350 Series Bridge Hardware Installation Guide

OL-1412-01

Chapter 2 Installation

Connecting the Ethernet Cables

Step 3 Connect the other end of the Ethernet cable to the device that will supply power.

If you are using a power injector, follow these additional steps:

a. Plug the straight-through, Category 5 Ethernet cable from the bridge into the port on the power

injector labeled To AP/Bridge.

Note Attach the provided warning labels to the powered Ethernet cable or the wall jack to warn other

users that the Ethernet connection carries inline power.

b. Plug a straight-through, Category 5 Ethernet cable into the port on the power injector labeled To

Network.

c. Plug the other end of the Ethernet cable into your 10/100 Ethernet switch, hub, or network.

d. Plug the female end of the power cord into the universal power supply.

e. Plug the male end of the power cord into a wall outlet or power strip.

f. Secure the power injector in place with the tie-wraps. Insert the tie-wraps through the slots on the

bottom of the power injector and fasten the tie-wraps around a pole or a bundle of wires, or use the

wall anchor and screw to secure the power injector to a wall.

At start-up, all three LEDs on the top of the bridge slowly blink amber, red, and green in sequence; the

power-up sequence takes a few minutes to complete. During normal operation, the LEDs blink green.

Refer to Chapter 4, “Troubleshooting,” for LED descriptions.

Step 4 Follow the steps in Chapter 3, “Basic Configuration,” to assign basic settings to the bridge.