Home | About | Contact

Cisco AS5300 Installation Manual

Download Appendix of Cisco AS5300 - Universal Access Server Adapter, Server for Free or View it Online on All-Guides.com.

Cisco AS5300 - Universal Access Server Appendix - Page 1
1
Cisco AS5300 - Universal Access Server Appendix - Page 2
2
Cisco AS5300 - Universal Access Server Appendix - Page 3
3
Cisco AS5300 - Universal Access Server Appendix - Page 4
4
Cisco AS5300 - Universal Access Server Appendix - Page 5
5
Cisco AS5300 - Universal Access Server Appendix - Page 6
6
Cisco AS5300 - Universal Access Server Appendix - Page 7
7
Cisco AS5300 - Universal Access Server Appendix - Page 8
8
Cisco AS5300 - Universal Access Server Appendix - Page 9
9
Cisco AS5300 - Universal Access Server Appendix - Page 10
10
Page 1
background image

A P P E N D I X

 Cabling Specifications D-1

D

Cabling Specifications

This appendix provides the following cabling and pinout information for the Cisco AS5300 
universal access server:

Console and Auxiliary Port Cables and Pinouts

Ethernet Port Pinouts

T1/PRI and E1/PRI Card Port Pinouts

T1/PRI and E1/PRI Card Cable Assemblies and Pinouts

Note

This appendix specifies pinouts only for the pins used. Pins not listed in the tables in this 

appendix are not connected.

Console and Auxiliary Port Cables and Pinouts

The access server arrives with a console and auxiliary cable kit, which contains the cable and 
adapters you need to connect a console (an ASCII terminal or PC running terminal emulation 
software) or modem to your access server. The console and auxiliary cable kit includes:

RJ-45-to-RJ-45 rollover cable. (See the next section, “Identifying a Rollover Cable,” for more 
information.)

RJ-45-to-DB-9 female DTE adapter (labeled TERMINAL).

RJ-45-to-DB-25 female DTE adapter (labeled TERMINAL).

RJ-45-to-DB-25 male DCE adapter (labeled MODEM).

For console connections, proceed to the section “Console Port Cables and Pinouts” later in this 
appendix; for modem connections, proceed to the section “Auxiliary Port Signals and Pinouts” later 
in this appendix.

Identifying a Rollover Cable

You can identify a rollover cable by comparing the two modular ends of the cable. Holding the cables 
side-by-side, with the tab at the back, the wire connected to the pin on the outside of the left plug 
should be the same color as the wire connected to the pin on the outside of the right plug. (See 
Figure D-1.) If your cable was purchased from Cisco Systems, pin 1 will be white on one connector, 
and pin 8 will be white on the other connector (a rollover cable reverses pins 1 and 8, 2 and 7, 3 and 
6, and 4 and 5).