Cisco DPC2434 Installation And Operation Manual
Download Installation and operation manual of Cisco DPC2434 Adapter, Gateway for Free or View it Online on All-Guides.com.
Brand: Cisco
Type: Installation and operation manual
Model: Cisco DPC2434 , Cisco EPC2434
Pages: 114 (2.66 Mb)
Install the Wireless Home Gateway
78-4011351-01 Rev B 21
2 Power off your PC and unplug it from the power source.
WARNING:
Avoid electric shock! Failure to unplug your PC from the power source may
create a shock hazard.
3 Connect your PC to either the Ethernet port or the USB port using the appropriate
data cable.
Note: You can connect two separate PCs to the wireless home gateway at the
same time by connecting one to the Ethernet port and one to the USB port.
4 Insert the AC power cord into the power connector on the back of the wireless
home gateway, and then plug the other end into an AC power source.
5 Plug in and power on your PC.
WARNING:
To avoid electric shock, disconnect your telephone company service at the
network interface device (demarcation point) before connecting the cable
modem telephone ports to your home telephone jacks.
6 Connect telephone port TEL1 (or Line 1 depending on your model) to your home
telephone jack. If your home is wired for a second telephone circuit, the connect
TEL2 (or Line 2 depending on your model) to the second telephone circuit.
7 Connect the active RF coaxial cable to the CABLE connector.
Note: Use an optional cable signal splitter to add a TV, a DHCT or set-top
converter, or a VCR.
8 The wireless home gateway will then begin an automatic search to locate and
sign on to the broadband data network.
Note: This process may take up to 5 minutes. The modem will be ready for use
when the ONLINE LED status indicator on the front panel stops blinking and
illuminates continuously.
9 Choose one of the following options:
To configure the TCP/IP protocol for Ethernet, go to Configure TCP/IP (on
page 22).
To install the USB Drivers for USB, go to Install USB Drivers (on page 25).