Cisco DPC2434 Installation And Operation Manual
Download Installation and operation manual of Cisco DPC2434 Adapter, Gateway for Free or View it Online on All-Guides.com.
Brand: Cisco
Type: Installation and operation manual
Model: Cisco DPC2434 , Cisco EPC2434
Pages: 114 (2.66 Mb)
Having Difficulty?
78-4011351-01 Rev B 53
My wireless home gateway does not recognize the cable network
The wireless home gateway works with a standard, 75-ohm, RF coaxial cable. If
you are using a different cable, your wireless home gateway will not function
properly. Contact your service provider to determine if you are using the correct
cable.
You may need to renew the IP address on your PC. Refer to How Do I Renew
the IP Address on My PC?, in this section, for instructions to renew the IP
address for your particular operating system.
Your USB interface may be malfunctioning. Refer to the troubleshooting
information in your USB documentation.
My wireless home gateway does not register an Ethernet connection
Even new devices do not always have Ethernet capabilities. Verify that your device
has an Ethernet card and that the Ethernet driver software is properly installed. If
you purchase and install an Ethernet card, follow the installation instructions very
carefully.
How Do I Renew the IP Address on My PC?
If your PC cannot access the Internet after the wireless home gateway is online, it is
possible that your PC did not renew its IP address. Follow the appropriate
instructions in this section for your operating system to renew the IP address on
your PC.
Renewing the IP address on Windows 95, 98, 98SE, and ME Systems
1 Click Start, and then click Run to open the Run window.
2 Type winipcfg in the Open field, and click OK to execute the winipcfg
command. The IP Configuration window opens.
3 Click the down arrow to the right of the top field, and select the Ethernet adapter
that is installed on your PC. The IP Configuration window displays the Ethernet
adapter information.
4 Click Release, and then click Renew. The IP Configuration window displays a
new IP address.
5 Click OK to close the IP Configuration window, you have completed this
procedure.
Note: If you cannot access the Internet, contact your service provider for further
assistance.