Cisco PLK200 User Manual
Download Operation & user’s manual of Cisco PLE200 Adapter for Free or View it Online on All-Guides.com.
Brand: Cisco
Category: Adapter
Type: Operation & user’s manual
Model: Cisco PLE200 , Cisco PLK200
Pages: 140 (10.24 Mb)
Chapter 3
Using the Configuration Utility
8
PowerLine AV Ethernet Adapter
Chapter 3
0-7 For each TOS bits user priority (7 being the highest
user priority), select the appropriate CAP setting: CAP3,
CAP2, CAP1, or CAP0 (CAP3 being the highest CAP
priority).
Default CAP - Lowest Priority
Set the default priority mapping of packets that do not
have priority set by VLAN tags, TOS bits, or other priority
mapping. For each type of traffic, select the appropriate
CAP setting.
IGMP For Internet Group Management Protocol (IGMP)
frames, select the appropriate CAP setting: CAP3, CAP2,
CAP1, or CAP0 (CAP3 being the highest CAP priority).
Unicast For unicast frames, select the appropriate CAP
setting: CAP3, CAP2, CAP1, or CAP0.
Multicast/Broadcast For multicast and broadcast frames,
select the appropriate CAP setting: CAP3, CAP2, CAP1, or
CAP0.
To save your changes, click the Save button.
To reset the priority settings to the factory defaults, click
the Restore Default button.
To exit the Configuration Utility, click Exit.
NOTE: The following are the factory default
settings for VLAN Tags and TOS Bits:
VLAN
Tag User
Priority
Default
CAP
Priority
TOS Bit
User
Priority
Default
CAP
Priority
0 CAP1 0 CAP1
1 CAP0 1 CAP1
2 CAP0 2 CAP2
3 CAP1 3 CAP3
4 CAP2 4 CAP3
5 CAP2 5 CAP3
6 CAP3 6 CAP3
7 CAP3 7 CAP3
Upgrade
Use this screen to upgrade the connected Adapter’s
firmware.
Upgrade Screen
Status Displayed here is the MAC address of the Adapter
currently accessed by your computer.
Device Information
MAC Address Displayed here is the MAC address of the
Adapter.
Firmware Version Displayed here is the firmware version
of the Adapter.
Device Upgrade
To upgrade the Adapter’s firmware, follow these
instructions:
Download the Adapter’s firmware from the Linksys
website at www.linksys.com or www.linksys.eu
(Go to the appropriate country for all downloads) .
Extract the firmware file on your computer.
Enter the location of the firmware’s file, or click the
Browse button to find the file.
Click the Upgrade button, and follow the on-screen
instructions.
To exit the Configuration Utility, click Exit.
1.
2.
3.
4.