Cisco WAE-674-K9 - Wide Area Application Engine 674 Installation Manual
Download Hardware installation manual of Cisco WAE-674-K9 - Wide Area Application Engine 674 Adapter, Network Card for Free or View it Online on All-Guides.com.
Brand: Cisco
Category: Adapter , Network Card
Type: Hardware installation manual for Cisco WAE-674-K9 - Wide Area Application Engine 674
Pages: 152 (4.9 Mb)
Download Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware installation manual
Chapter 6 Troubleshooting the System Hardware
Symptoms and Solutions
6-30
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
OL-15012-02
System Error LED and the Diagnostic Panel LEDs
The system error LED is on when an error is detected. If the system error LED is
on, remove the cover and check the diagnostic panel LEDs.
Table 6-8 lists all the
diagnostic panel LEDs followed by the component or action for correcting the
problem. The information in the table is valid only when the system error LED
is on.
When checking the diagnostic panel LEDs, note the following information:
• If a diagnostic panel LED is on and the front panel system error LED is off,
there is probably an LED problem. Run the LED diagnostics.
• To locate the LEDs on the system board, see Figure 6-3 on page 6-19.
• Check the system error log for additional information before replacing a
component. (See the
“Viewing Error Logs” section on page 6-10.)
• The DIMM error LEDs, microprocessor error LEDs, and VRM error LEDs
on the system board go off when the system is powered down.
Table 6-8 provides the diagnostic panel LED error definitions. The third column
lists one or more suggested actions or components that need to be reseated or
replaced. Use this table to identify possible causes for the error message and then
call your customer service representative.
Ta b l e 6-8 Diagnostic-Panel LED Error Definitions
Diagnostic-Panel
LED
Description Cause and Action
None, but the
System Error
LED is lit.
An error has occurred and cannot
be diagnosed, The error is not
represented by a light path
diagnostics LED.
Use the Configuration/Setup utility program to
check the system error log for information
about the error. See
Appendix C, “Using the
Configuration/Setup Utility Program.”
OVER SPEC The power supplies are using
more power than their maximum
rating.
1. Remove optional devices from the WAE.
2. Replace the failing power supply.
PS1 The power supply in bay 1 has
failed.
1. Check the DC good LED on
power
supply 1. If it is off, power supply 1
needs to be replaced.
2. Check that the power supply is correctly
seated.