Cisco WAE-674-K9 - Wide Area Application Engine 674 Installation Manual
Download Hardware installation manual of Cisco WAE-674-K9 - Wide Area Application Engine 674 Adapter, Network Card for Free or View it Online on All-Guides.com.
Brand: Cisco
Category: Adapter , Network Card
Type: Hardware installation manual for Cisco WAE-674-K9 - Wide Area Application Engine 674
Pages: 152 (4.9 Mb)
Download Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware installation manual
Chapter 6 Troubleshooting the System Hardware
Symptoms and Solutions
6-34
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
OL-15012-02
For all remaining error codes, the solution is to check the component or take the
action indicated.
Table 6-9 lists all the diagnostic error codes. Use this table to
identify a faulty component, and then call your customer service representative
for assistance.
Ta b l e 6-9 Error Code Definitions
Error Code Problem Action
001-XXX-000 Failed core tests. Check the system board.
001-XXX-001 Failed core tests. Check the system board.
001-250-000 Failed system board ECC. Check the system board.
001-250-001 Failed system board ECC. Check the system board.
005-XXX-000 Failed video test. 1. Reseat the video adapter.
2. Check the system board.
011-XXX-000 Failed COM1 serial port test. Check the system board.
011-XXX-001 Failed COM2 serial port test. Check the system board.
014-XXX-000 Failed parallel port test. Check the system board.
015-XXX-001 USB
1
interface not found; board
damaged.
Not applicable. The USB interface is not
supported in the WAAS software.
015-XXX-015 Failed USB
1
external loopback
test.
Not applicable. The USB interface is not
supported in the WAAS software.
015-XXX-198 USB
1
device connected during
USB test.
Not applicable. USB peripheral devices are not
supported in the WAAS software.
020-XXX-000 Failed PCI interface test. 1. Reseat the riser-card assembly.
2. Check the system board.
030-XXX-099 Failed internal SCSI interface
test.
Check the system board.
035-285-001 Adapter Communication Error. 1. Update the ServeRAID SAS controller
firmware.
2. Reseat the ServeRAID SAS controller.
3. Replace the ServeRAID SAS controller.