Cisco RV0041 Quick Install

Download Quick install of Cisco RV0041 Network Router for Free or View it Online on All-Guides.com.

Brand: Cisco

Category: Network Router

Type: Quick install for Cisco RV0041

Pages: 2 (0.21 Mb)

Download Cisco RV0041 Quick install

Cisco RV0041 Quick install - Page 1
1
Cisco RV0041 Quick install - Page 2
2
Model No.
Quick Installation
Quick Installation
A Division of Cisco Systems, Inc.
®
Model No.
WIRED
RV0041
VPN Router
10/100/1000 4-Port
Package Contents
10/100/1000 4-Port VPN Router
•User Guide CD-ROM
AC Power Cable
Rack Mounting Kit
Quick Installation
Registration Card
1
A Before you begin, make sure
that all of your hardware is
powered off, including the
Router, PCs, hubs, switches,
and cable or DSL modem.
B Connect one end of an Ether-
net network cable to one of
the numbered ports on the
front of the Router. Connect
the other end to an Ethernet
port on a network device, e.g.,
a PC, print server, hub, or
switch.
Repeat this step to connect
more PCs or other network
devices to the Router.
C Connect your cable or DSL
modem’s Ethernet cable to
the Router’s Internet port.
D Power on the cable or DSL
modem and the other network
device if using one.
2
Connect the Router
In Step 2, you will need the setup
instructions provided by your Inter-
net Service Provider (ISP). If you do
not have this information, then con-
tact your ISP before proceeding.
The instructions from your ISP tell you
how to set up your PC for Internet
access. Because you are now using
the Router to share Internet access
among several computers, you will
use the setup information to config-
ure the Router instead of your PC.
A Open your PC’s web browser.
Enter http://192.168.1.1 (the
Router’s default local IP
address) in the web browser’s
Address field. Then press the
Enter key.
B A screen will appear and ask
you for a User Name and Pass-
word. Enter admin (the default)
in the the User Name and Pass-
word fields. Then click the OK
button.
E
B
Configure the Router
A
E Connect the included AC
power cable to the Router’s
Power port on the back of the
Router, as shown in Figure E,
and then plug the other end of
the power cable into an elec-
trical outlet.
The System LED on the front
panel will light up as soon as
the power adapter is con-
nected properly.
NOTE:: Make sure your PC’s Ethernet
adapter is set to obtain an IP address
automatically. For more information,
refer to Windows Help.