Proroute H820 Quick Start Manual
Download Quick start manual of Proroute H685 Network Hardware, Network Router for Free or View it Online on All-Guides.com.
Brand: Proroute
Category: Network Hardware , Network Router
Type: Quick start manual
Model: Proroute H685 , Proroute H820
Pages: 2
1
2
PROROUTE
H820 / H685
QUICK START GUIDE
PROROUTE H820 / H685 QUICK START
Thank you for your purchase. We have included in this quick start guide the basics of getting your router connected to the Internet and configure basic services. For full installation instructions and help guides and videos please
visit the support section at www.proroute.co.uk.
PRODUCT DESCRIPTION
PROROUTE PROROUTE
H685 3G/4G H820 3G/4G
ROUTER ROUTER
STEP 1
INSERT SIM (Ensure Power is OFF)
PROROUTE H685 (3G and 4G)
• Remove SIM cover by unscrewing the two retaining screws.
• Lift SIM holder, insert SIM and push SIM holder into place.
• Replace SIM cover and screws.
PROROUTE H820 (3G and 4G)
• Remove SIM cover
• Insert SIM into slot (connector side down, cut-off corner in
rst) – Push in ALL the way and you will hear a small click and
then release SIM – the SIM should remain in place. It helps to
use a pen or screwdriver to ensure it is pushed in all the way. To
remove SIM – press in and it will pop out.
• Replace SIM cover and screws.
STEP 2
CONNECT ANTENNAS (Ensure Power is OFF)
Connect Cellular Antennas and Wi-Fi antenna (if needed). Cell
antennas connect to ANT1 (Main) and ANT2 (Aux) and the Wi-Fi
antenna to ANT3. The supplied antennas are for internal use only.
We recommend using the Mag Mount Antennas supplied for
best performance but if installing the unit in a very good signal
location then the optional stick type antennas may be used.
The Mag Mount antennas will need to be xed in a horizontal
position on a metal surface at least 30cm square and if using
the MAIN and AUX antennas these should be placed at least
60cm apart. If you are unable to correctly install the Magnetic
Antennas then we suggest using the stick antennas for optimum
performance.
Note: Please note the comments at Point 6 relating to operational
environment.
STEP 3
POWER ON THE ROUTER
Once you have inserted the SIM card and connected the
antennas you are now ready to power up the unit. Simply
connect the power adapter, plug into the mains and power on.
The router will take about two minutes to complete the start-up
process before you will be able to connect to the web browser
interface.
The SYS light will ash steadily every 2 seconds – this is normal.
STEP 4
CONNECT YOUR PC TO THE ROUTER AND
ACCESS THE WEB INTERFACE
Set your Laptop / PC to obtain an IP address automatically and
using an Ethernet / LAN cable (Patch lead) connect to one of the
LAN ports of the router.
The router will then allocate your PC with an IP address. If you
do not receive an IP address please double check that you have
connected to a LAN port and not inadvertently connected to a
WAN port.
Within the top bar (address bar) of your browser type
http://192.168.8.1 hit ‘enter’ key. This will bring up the
administration interface of the Proroute.
Default User name is: admin
Default Password is: admin
ONCE YOU ARE LOGGED INTO THE ROUTER WE
RECOMMEND THAT YOU UPGRADE TO THE LASTEST
FIRMWARE WHICH CAN BE FOUND AT WWW.PROROUTE.
CO.UK WHERE YOU WILL ALSO FIND UPGRADE
INSTRUCTIONS.
SUPPORT
Please contact your hardware supplier in the first
instance for support.
WARRANTY
All Proroute routers are covered by a 12 month
return to base warranty.
MAIN ANTENNA | AUX ANTENNA | SERIAL INTERFACE | 4 LAN ports | WAN port | WIFI ANTENNA | POWER
(factory reset)
LAN WAN