• Home
• Brands
• Cobra Manuals
• Cobra MicroTalk FRS 104
• Cobra MicroTalk FRS 104 Instructions Manual

Cobra MicroTalk FRS 104 Instructions Manual

Download Instructions manual of Cobra MicroTalk FRS 104 Transceiver, Two-Way Radio for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

Insert round connector of

110 volt adapter into jack

on back of charger.

Plug 110 volt adapter into

electrical outlet.

The CHARGE indicators light

will stay on as long as the

radio or battery pack is in the

charging well, even after the

batteries are fully charged.

It normally takes about 15 hours

to fully recharge batteries.

Batteries will not be damaged if

they stay in the charging well

longer than that.

FA-CF

Desktop

Charger

English

Family Radio Service Transceivers

Instructions

1

2

3

For use with Cobra® microTALK®

models FRS 104, FRS 130, FRS 235

and FRS 307 fitted with charge

contacts in the battery door.

Note

Not all models include charge

contacts in the battery door.

Each port can charge one

radio or one NiMH battery

pack model FA-BP.

Uses 110 Volt adapter .

Note

If you put your batteries in the

wrong way, the CHARGE light

will not turn on.

Important

Use only Cobra® Nickel Metal

Hydride Battery Pack (NiMH),

model FA-BP with charger

model FA-CF.

Cobra® recommends your FRS

radio is TURNED OFF while being

charged.

For charging Cobra®’s

microTALK® radio:

Take the plastic battery pack

guides out of the desktop

charger and insert radio. If

charging light is not on, check

position of FRS Radio. Radio

should be upright.

For charging Batteries:

With the plastic battery pack

guides in place, place battery

inside cavity so contacts are

touching the back wall inside

the cavity.

Note

In order to use the FA-CF charger

with model FRS 307, you must

remove the insert at the bottom of

the charger cavity well.This insert

is fitted with a tab that protrudes

approximately 1/8”from the

bottom of the charger cavity well.

This insert is in place for use with

models FRS 104, FRS 130, and

FRS 235.However, when using the

charger with model FRS 307,you

must remove the insert. Refer to

illustration below for the location

of this insert,and use you fingers

or a suitable tool (i.e.tweezers) to

remove the insert prior to using

the charger with the FRS 307.

INSERT

CHARGE CRADLE