Compaq 234664-002 - ProLiant - ML330T02 Setup And Installation Manual
Download Setup and installation manual of Compaq 234664-002 - ProLiant - ML330T02 Desktop for Free or View it Online on All-Guides.com.
Brand: Compaq
Category: Desktop
Type: Setup and installation manual for Compaq 234664-002 - ProLiant - ML330T02
Pages: 160 (4.2 Mb)
Download Compaq 234664-002 - ProLiant - ML330T02 Setup and installation manual
RAID Configuration and Management 6-5
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330 Generation 2 Server Setup and Installation Guide Comments:
Part Number: 234833-001 File Name: g-ch6 Integrated ATA RAID Utility.doc Last Saved On: 6/28/01 1:22 PM
Help
The Help window displays hints on available options and provides a list of
keys that you can use to perform tasks, such as:
■ Switch Windows (TAB)—switches the control back and forth between
the Array Information and the Physical Drive Information windows.
■ Auto Configure RAID 0 (F1)—automatically creates and configures a
striped array based on the available physical drives installed.
■ Auto Configure RAID 1 (F2)—automatically creates and configures a
mirrored array based on the available physical drives installed. You
must have a minimum of two free hard drives in the array.
■ Auto Configure RAID 0+1 (F3)—automatically creates and configures
a RAID 0+1 array based on the available physical drives installed. You
must have a minimum of four hard drives in the array.
IMPORTANT: All previous settings are lost when the Auto Configure option is run for
striped, mirrored, and RAID 0+1 arrays.
■ Create Array (F4)—creates a drive array. When this option is selected,
a default array template is created. You must edit the array properties to
complete the array creation. Use the arrow keys to highlight a property
field, and then press the Enter key to edit that property. The array
properties are as follows:
G Array Type—selects the intended RAID mode including RAID 0,
RAID 1, RAID 0+1, and Spare. The default for the Array Type
option is RAID 0.
G Drive(s)—selects the drives for the array. This option refers to the
drive number listed in the Physical Drives Information box, not the
number of drives in the array. Use the arrow keys, and then press the
spacebar to select or deselect the drive or drives. Press the Enter key
when done. There is no default for this setting.
G Stripe Size—changes the stripe size. This field applies only to
RAID 0 arrays. The default stripe size is 64 KB.
IMPORTANT: RAID configurations do not support a stripe size less than 32 KB.
IMPORTANT: You cannot change the stripe size of an array that has been already
configured.