• Home
• Brands
• Compaq Manuals
• Compaq 203039-B21 - Console Management Controller
• Compaq 203039-B21 - Console Management Controller Installation Instructions

Compaq 203039-B21 - Console Management Controller Installation Instructions

Download Installation instructions of Compaq 203039-B21 - Console Management Controller Door, Other for Free or View it Online on All-Guides.com.

1

2

3

4

About This Device

These instructions serve as an outline to assist qualified person-

nel with the installation of the optional sensors for the Compaq

Console Management Controller (CMC).

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS - This document contains

important instructions for additional sensors to be used with the

CMC Kit, that should be followed during installation.

NOTICE

The information in this publication is subject to change without notice.

COMPAQ COMPUTER CORPORATION SHALL NOT BE LIABLE FOR

TECHNICAL OR EDITORIAL ERRORS OR OMISSIONS CONTAINED HEREIN,

NOR FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM

THE FURNISHING, PERFORMANCE, OR USE OF THIS MATERIAL. THIS

INFORMATION IS PROVIDED “AS IS” AND COMPAQ COMPUTER

CORPORATION DISCLAIMS ANY WARRANTIES, EXPRESS, IMPLIED OR

STATUTORY AND EXPRESSLY DISCLAIMS THE IMPLIED WARRANTIES OF

MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE, GOOD TITLE

AND AGAINST INFRINGEMENT.

This publication contains information protected by copyright. No part of

this publication may be photocopied or reproduced in any form without

prior written consent from Compaq Computer Corporation.

© 2001 Compaq Computer Corporation

Compaq, Registered U.S. Patent and Trademark Office.

COMPAQ CMC SENSOR KIT

INSTALLATION INSTRUCTIONS

First Edition (March 2001)

Part Number 218259-021

Compaq Computer Corporation

CMC SENSOR KIT

Printed on recycled paper

Read Instructions Completely Before

Beginning Installation Procedures

Installation Instructions for

CMC Sensor Kit

Important Safety Information

Read Before Installing Product

Please refer to the Important Safety Information (guide

included with the CMC kit) before installing this product.

Kit Contents

n Temperature sensor (1)

n Intrusion sensor (2 sets)

n Mechanical shock/vibration sensor (1)

n Humidity sensor (1)

n Mounting hardware

o Screws

o Humidity sensor mounting bracket

o Double sided tape

o Tie wraps

o Cable management clips

n Package of sensor cables – assorted lengths

Temperature Sensor

The temperature sensor can be installed on the ceiling of the rack

towards the rear, or near the most temperature-sensitive component

in the rack.

Intrusion Sensor

An intrusion sensor consists of two parts: a magnet and an

electrical switch. The magnet should be installed on the inside of

the rack door and the electrical switch on the rack as shown

below. Make sure the magnet and switch align; allow sufficient

clearance for the doors to close. The intrusion sensors should be

installed on the front door of the rack, as well as the rear

door .

WARNING: There is a risk of personal injury from electrical shock

and hazardous energy levels. The installation of options and routine

maintenance and service of this product must be performed by

individuals who are knowledgeable about the procedures, precau-

tions, and hazards associated with AC power products.

1 2

1 2

9000 series rack

7000 series rack

The intrusion sensor is delivered with a terminating plug in the

upper connector. The terminating plug must be connected as

shown. To daisy-chain multiple intrusion sensors to a single CMC

port, the terminating plug must be removed and the plug from

the next intrusion sensor in line connected in its place.

21

1

Installing the Sensors

7000 series rack

9000 series rack

Mechanical Shock/Vibration Sensor

The mechanical shock/vibration sensor should be installed on the

rails of the rack.

218259- 021

The sensor cables can be routed through the rack and then

attached to the rack by using the stick-on cable management clips

or tie wraps.