• Home
• Brands
• Cornelius Manuals
• Cornelius Agitator Motor 569000207
• Cornelius Agitator Motor 569000207 Installation Manual

Cornelius Agitator Motor 569000207 Installation Manual

Download Installation manual of Cornelius Agitator Motor 569000207 Beverage Dispenser for Free or View it Online on All-Guides.com.

1

2

EIMI Cornelius Inc; 1997

May 20, 1997

560001744

IMI CORNELIUS INC g One Cornelius Place g Anoka, MN 55303-6234

Telephone (800) 238-3600 Facsimile (612) 422-3246

INSTALLING REPLACEMENT AGITATOR MOTOR

KITS (P/N 569000207 AND P/N 569000208)

ON

VANTAGE DISPENSERS

IMPORTANT: Only qualified Personnel should install this kit.

Unpack and inspect the kit. Make sure all kit items are present and in good condition.

Table 1. Loose-Shipped Parts

Item

No. Part No. Name Qty.

1 314072000

314150000

Agitator Motor Ass’y, 115 VAC (Kit P/N 569000207)

Agitator Motor Ass’y, 230 VAC (Kit P/N 569000208)

1

1

2 319828000 Screw, Thread Rolling, Phil Pn Hd; No. 10–24, .375 Long 3

3 560001745 Mounting Template 1

4 000268010 Drill Bit, 5/32 1

REMOVING OLD AGITATOR MOTOR ASSEMBLY

WARNING: Disconnect electrical power from the Unit to prevent personal injury before

attempting any internal maintenance. Only qualified personnel should service the internal

components or electrical wiring.

1. Disconnect electrical power from the Dispenser.

2. Remove hood from Dispenser, then remove cover from electrical control box (see Figure 1).

3. Disconnect old agitator motor assembly electrical wires from L

1

and L

2

terminals on the PC board (see

Figures 1 and 4) inside the electrical control box.

4. Remove old agitator motor assembly from refrigeration deck. Discard old motor and it’s mounting screws.

INSTALLING NEW AGITATOR MOTOR ASSEMBLY

1. Cut out “AGIT PORT CUT-OUT” area of the MOUNTING TEMPLATE (item 3) with a scissors as shown in

Figure 2. Remove adhesive covering from back side of the mounting template, then place template (align

template holes with existing agitator motor mounting holes) over the existing agitator motor cut-out in the

refrigeration deck.

2. Temporarily install the electrical control box cover to protect the PC boards from metal shavings while

drilling. Center punch two hole locations indicated on the mounting template, then using DRILL BIT (item 4)

drill indicated holes in the refrigeration deck.