Groov -AT1 Quick Start Manual

Download Quick start manual of Groov GROOV-AT1 Network Hardware for Free or View it Online on All-Guides.com.

Brand: Groov

Category: Network Hardware

Type: Quick start manual for Groov GROOV-AT1

Pages: 2

Download Groov GROOV-AT1 Quick start manual

Groov GROOV-AT1 Quick start manual - Page 1
1
Groov GROOV-AT1 Quick start manual - Page 2
2
Form 2063-140602—June 2014 © 2014 Opto 22. All rights reserved. Printed in the United States.
Connect the power supply
Plug the small connector on the power supply into the power terminal on the
bottom of the
groov Box
, and tighten the screws. Plug the other end into a
standard 120 or 240 VAC outlet.
Get Started
Activate the groov Box and get the
license file
a.
Open a web browser (Firefox or
Chrome recommended) and go to
activate.groov.com
.
b.
Log in using your email address and
your My.Opto22 password.
You may have set up your free
My.Opto22 account when you
purchased your
groov
Box. If you don’t
have a My.Opto22 account, enter your
email address and other information,
and the account will be created.
c.
Follow the on-screen instructions to activate your
groov
Box and download the
license file.
When asked to enter the serial number, you’ll find it on the label on the top of
the device.
Connect to the network
Quick Start
for GROOV-AT1
Open
Unpack the groov Box
You need:
A computer with a modern web browser on the same network you’ll use for the
groov
Box. We recommend Chrome, Firefox, or Internet Explorer 10.
One of the following, on the same network as your computer. The network
should have DHCP & DNS.
An OPC UA-compatible tag server communicating with virtually any
automation system or equipment
A PAC S-series, PAC R-series, or SoftPAC controller with firmware R9.2a or
newer, running a strategy developed in Opto 22’s PAC Control
Serial number
Turn on the groov Box
Briefly press and release the On/Off button. Wait until the SYS LED has stopped
blinking and is solid green. Also, take a look at the LNK ACT light for ETH0. If the
cable is properly connected, the LNK ACT light should be on or blinking.
In the box...
Ethernet cable
CD
groov Box (GROOV-AT1)
Antennas
(attach before use)
Spare fan filters
Power supply
Activation key
certificate
Connect ETH0 to your
computer’s network.
If you have a separate control network,
see the
groov Box User’s Guide.
LNK ACT light
For detailed information on setting up your
network, and setting up communications
over the Internet, see form 1796, the
Guide
to Networking Opto 22 Products.
To set up the groov Box, you’ll use the
groov
Box components shown below.
Peel the label from the Activation Key Certificate and affix it to the top of the
groov
Box.
When deciding where to place the
groov
Box, make sure there is room around the
front, top, and sides of the
groov
Box to allow air to flow freely around the device.
You need to be able to see the information on the bottom.
On/Off button
LEDs
ETH0
Airflow
Power terminal
Affix the Activation
Key label here.