SRX240 Services Gateway Quick Start
Follow the instructions in this quick start to connect the SRX240 Services Gateway to
your network. For details, see the SRX240 Services Gateway Hardware Guide at
http://www.juniper.net/techpubs/en_US/release-independent/junos/information-products/
pathway-pages/srx-series/product/index.html.
SRX240 Services Gateway Front Panel
SRX240 Services Gateway Back Panel
SRX240 Services Gateway Models
The following models of the SRX240 Services Gateway are available:
NOTE: On the SRX240H-POE,SRX240H2-POE, SRX240H-POE-TAA, and
SRX240H2-POE-TAA models, Power over Ethernet (PoE) of a maximum of 150 watts is
supported on all the16 ports (0/0 through 0/15).
Connecting and Configuring the SRX Series Services Gateway
Follow these instructions to connect and set up the SRX240 Services Gateway. The
LEDs on the front of the device indicate the status of the device.
Configuration Overview
The SRX240 Services Gateway requires the following basic configuration settings to
function:
Interfaces must be assigned IP addresses.
Interfaces must be bound to zones.
Policies must be configured between zones to permit or deny traffic.
Source NAT rules must be set.
The device has the following default configuration set when you power it on for the first
time. To use the device, you do not need to perform any initial configuration.
Callout Description Callout Description
1 Mini-PIM slots 5 Console port
2 Power button 6 Gigabit Ethernet (0/0 to 0/15) ports
3 LEDs (ALARM, POWER,
STATUS, HA, mPIM)
7 USB ports
4 Reset Config button
Callout Description Callout Description
1 Cable tie holder 3 Grounding point
2 Power supply input
