Dacor EF36IWF Planning Manual
Download Planning manual of Dacor EF36IWF Refrigerator for Free or View it Online on All-Guides.com.
1
PLANNING
GUIDE
11.14
Specications subject to change without notice. Phone: (800) 793-0093www.dacor.com
EF36IWF
Product Dimensions
■ The depth from the front of the door (w/o door handles) to the back of
the refrigerator chassis is 26 1/2” (67.3 cm).
■ The depth of the cabinet less the door is 23 3/4” (60.3 cm).
■ The power cord is 60” (152.4 cm) long.
■ The height from the top of the refrigerator to the floor with the leveling
legs in the down position is 70 1/8” (178.1 cm).
■ The height from the top of the refrigerator to the floor with the leveling
legs in the fully extended position is 70 3/4” (179.7 cm) at the front of
the unit.
■ The refrigerator width from edge to edge is 35 5/8” (90.5 cm).
Location Requirements
The refrigerator can be recessed in an opening between cabinets or
installed at the end of a cabinet run using a side panel to enclose it.
■ To ensure proper ventilation for your refrigerator, allow for a 1/2”
(13 mm) space at the top and 1" (2.5 cm) behind the refrigerator.
■ The location must allow the refrigerator to be moved out from the
wall without being disconnected in the event that service become
necessary.
■ Do not install the refrigerator in a location where the temperature will
fall below 55°F (13°C).
■ Allow a minimum of 2 1/2” (6.4 cm) space between the side of the
refrigerator and an oven or range.
■ The floor must be able to support the refrigerator’s weight of more
than 600 lbs (272 kg), the door panels and the refrigerator contents.
WARNING
• Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
• This appliance must be installed in accordance with the
accompanying installation instructions.
■ The area to the left and the right of the appliance must permit both
doors to open to a minimum of 90°. Allow space between the side of
the refrigerator doors and a corner wall for the handle and/or custom
door panels.
■ A grounded three prong non-GFCI electrical outlet must be provided
and should be in a location that allows the refrigerator to be
connected without an extension cord. See “Electrical Requirements”
for additional information.
■ The plumbing for the water line can come through the floor flush to
or from the back wall. Install the water valve in a location that allows
it to be turned off without moving the refrigerator out in the event the
refrigerator or water line requires service.
Electrical Requirements
A 115 Volt, 60 Hz. AC only 15 or 20 Amp. fused, grounded electrical supply
is required. It is recommended that a separate circuit serving only your
refrigerator be provided. Use an outlet that cannot be turned off by a switch.
Do not use an extension cord.
Water Supply Requirements
■ A cold water supply with water pressure of between 35 and 120 p.s.i.
(241 and 827 kPa) is required to operate the water dispenser and
ice maker. If you have questions about your water pressure, call a
licensed, qualified plumber.
■ Install a shut off valve between the refrigerator and water supply. Use
1/4” copper tubing with a compression nut and compression sleeve
and check for leaks. Allow a minimum of 24” (61.0 cm) diameter
service loop of copper tubing outside the wall or floor for easy
connection to the water supply. Install copper tubing only in areas
where the household temperatures will remain above freezing.
■ Do not use a piecing type or 3/16” (5 mm) saddle valve which will
reduce water flow and clog more easily.
■ IMPORTANT: The pressure of the water supply coming out of
a reverse osmosis system going to the water inlet valve of the
refrigerator needs to be between 35 and 120 p.s.i. (241 and 827
kPa). If a reverse osmosis water filtration system is connected to your
cold water supply, the water pressure to the reverse osmosis system
needs to be a minimum of 40 to 60 p.s.i. (276 to 414 kPa).
Document # PG11-010 Revised 08/10/11 Page 1/1
36 Inch Wide Freestanding
Refrigerator with In-Door Dispenser
70 1/2” min.*
(179.1 cm)
36” min. (91.4 cm)
*Add 2 1/2” (6.4 cm) for the optional top gril kit (AFG36).
Suggested electrical location
approximate dimensions
12” (30.5 cm)
24” (61.0 cm)
12”
(30.5 cm)
EPICURE STYLE HANDLE DIMENSIONS (PN AFE36H3L)
MILLENNIA STYLE HANDLE DIMENSIONS (PN AFM36H3L)
B
A
C
A
B
C
A = 13/16" (2.1 cm)
B refrigerator = 32 3/4" (83.2 cm)
B freezer drawer = 25 1/2" (64.8 cm)
C = 2 3/8" (6.0 cm)
A = 1 1/2" (3.8 cm)
B refrigerator = 40" (101.6 cm)
B freezer drawer = 33 1/2" (85.1 cm)
C = 2 1/2" (6.4 cm)