Danby DR299BLSGLP Owner's Use And Care Manual
Download Owner's use and care manual of Danby DR299BLSGLP Cooktop, Kitchen Appliance for Free or View it Online on All-Guides.com.
Brand: Danby
Category: Cooktop , Kitchen Appliance
Type: Owner's use and care manual for Danby DR299BLSGLP
Pages: 47 (0.75 Mb)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
L.P.
Nat.
13. Make sure Range is level
Level the range by placing a level horizontally on an oven rack. Check diagonally from front to back; then level the range by
either adjusting the leveling legs or by placing shims under the corners of the range as needed.
14. After installation is complete, make sure all controls are left in the OFF position
Model and Serial Number Location
The serial plate is located on the right-hand surface of the oven front frame at the broil drawer; or the lower panel.
When ordering parts for or making inquires about your range, always be sure to include the model and serial numbers from
the serial plate on your range.
Your serial plate also tells you the rating of burners; the type of fuel and the pressure the range was adjusted for when it left
the factory.
Gas Conversion
This range was adjusted at the factory for Natural gas as specified on the serial plate and it is equipped with fixed orifices and a
convertible appliance pressure regulator.
To convert the unit from Natural gas to LP gas will require the replacement of the orifice hoods, and adjustment of air shutters
on the burners and adjustment of the appliance pressure regulator converter cap.
Inlet pressure to the appliance pressure regulator shall be in accordance with the nominal inlet pressure of the regulator used
on the range (14 inches of water column pressure or ½ PSIG maximum) The range should be tested by pressurizing the
regulator with an inlet pressure at least 1 inch water column above the manufacture’s specified manifold pressure shown on
the serial plate, as follow:
INLET PRESSURE IN
INCHES OF WATER COLUMN
NAT
GAS
LP
GAS
Minimum 5 11
Maximum 14 14
a. Appliance Pressure Regulator Conversion
:
The regulator is located at rear of the range.
• Using a screw or coin, turn the cap counterclockwise to release
from the pressure regulator. Be sure the O-ring gasket stays in
place.
• Turn the cap over and place into the slots. Turn clockwise to lock
in position. The letters corresponding with the type of gas being
used should be visible on the exposed end of the cap.
b. Orifices Conversion
:
To convert this unit to LP gas from Natural gas will require the
exchange of orifice hoods.
IMPORTANT: Save the orifices removed from the appliance for
future use.