DANBY DDW2405W Instruction Manual
Download Instruction manual of Danby DDW2405W Dishwasher for Free or View it Online on All-Guides.com.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
OVERFLOW CONDITIONS:
The dishwasher is designed to detect/monitor water overflow conditions. The overflow tube is located in
the lower section of the inner door liner. This tube must be kept free and clear of obstructions and
debris. In the event of an overflow condition, the water level rises above the height of the overflow tube
and is directed into the overflow container.(located at the lower right side of the dishwasher) When the
water level reaches a predetermined height, the float switch is activated closing power to the water inlet
valve and automatically turns on the pump to evacuate the water inside the tub only. The accumulated
water inside the float container must be discharged manually before the dishwasher can be re-started.
To empty the float container, follow the instructions below.
Before you start;
* Disconnect the dishwasher from the
electrical power supply.
* Turn off the water supply using the shut-off
valve located next to the dishwasher or main
household shut-off valve.
* Remove the kick-plate.
* Disconnect the flexible (braid) hose
from the water inlet valve.
* The overflow container is located at the lower
right side of the dishwasher underneath the
insulation jacket. (See Fig. 1)
* Carefully slide out the dishwasher just
enough to access the overflow container,
approximately 12" (30.4 cm).
A MPORTANT: Keep the dishwasher
upright at all times.
To drain the overflow container;
1. Remove the rubber plug from the bottom
of the float container. (See Fig. 2)
2. Allow the water to drain into a cup or
container.
3. Replace the rubber plug, making sure
it is firmly secured.
4. Re-install the kick-plate.
5. Carefully slide the dishwasher back
into the cabinet.
The dishwasher is now ready to be restarted.
Fig_
,¢., ? "_.
Plug
13