• Home
• Brands
• Danby Manuals
• Danby DCD5505W
• Danby DCD5505W Owner's Manual

Danby DCD5505W Owner's Manual

Download Owner's manual of Danby DCD5505W Dryer for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

INSTALLATION INSTRUCTIONS

Instructions for Use

8

• Insert the 4- wire supply cord through both

sections of the strain relief and re-install strain

relief screws, do not fully tighten until electrical

connections are complete.

• Attach the power cord ground conductor (green

wire) to the ground terminal marked with the

ground symbol. Tighten screw until ground

conductor is secure. (See Fig. 7)

• Attach the power cord neutral conductor (white

wire) to the neutral terminal. (marked N)

Tighten screw until neutral conductor is secure.

(See Fig. 7)

• Attach the power cord phase conductor (black

wire) to the phase terminal (marked L3).

Tighten screw until power conductor is secure.

(See Fig. 7)

• Attach the power cord phase conductor (red

wire) to the phase terminal (marked L1).

Tighten screw until power conductor is

secure.(See Fig. 7)

• Tighten the screws on the strain relief so that

the power cord cannot be moved.

• Re-install the cover of the junction box and

secure with four screws removed earlier.

• The dryer is now ready to be connected to the

power supply receptacle.

Three-wire connection

Junction box

Fig. 8

To connect power cord:

• Remove the screws from the cover of the

junction box located at the top rear of the dryer.

• Loosen/remove the two screws on the strain

relief clamp and remove from 3-wire supply

cord.

• The strain relief splits into two indentical parts.

• Insert the large flange of both sections into the

hole located on the left side of the junction box

housing. The short flange of both sections and

screws must remain positioned on the external

side of the junction box housing.

• Insert the 3- wire supply cord through both

sections of the strain relief and re-install the

strain relief screws, do not fully tighten until

electrical connections are complete.

• Attach the power cord ground conductor (green

wire) to the ground terminal marked with the

ground symbol. Tighten screw until ground

conductor is secure. (See Fig. 8)

• Attach the two remaining power cord phase

conductors ( left = black wire and right = red

wire ) to the phase terminals (marked L3 & L1).

Tighten screws so that the power conductors

are secure. (See Fig. 8)

• Tighten the screws on the strain relief so that

the power cord cannot be moved.

• Re-install the cover of the junction box and

secure with four screws removed earlier.

• The dryer is now ready to be connected to the

power supply receptacle.

Note:

The receptacle should be located so that the plug

and receptacle will be accessible with the dryer in

its installed position.

Additional Grounding Procedure

Some local codes may require a separate

ground. In such cases, the required accessory

ground wire, clamp and screw must be

purchased separately.

Never ground the dryer to plastic plumbing lines,

gas lines or hot water pipes.