Davis WeatherLink Started Manual

Download Addendum of DAVIS WeatherLink Software, Weather Station for Free or View it Online on All-Guides.com.

Brand: DAVIS

Category: Software , Weather Station

Type: Addendum for DAVIS WeatherLink

Pages: 20 (0.45 Mb)

Download DAVIS WeatherLink Addendum

DAVIS WeatherLink Addendum - Page 1
1
DAVIS WeatherLink Addendum - Page 2
2
DAVIS WeatherLink Addendum - Page 3
3
DAVIS WeatherLink Addendum - Page 4
4
DAVIS WeatherLink Addendum - Page 5
5
DAVIS WeatherLink Addendum - Page 6
6
DAVIS WeatherLink Addendum - Page 7
7
DAVIS WeatherLink Addendum - Page 8
8
DAVIS WeatherLink Addendum - Page 9
9
DAVIS WeatherLink Addendum - Page 10
10
DAVIS WeatherLink Addendum - Page 11
11
DAVIS WeatherLink Addendum - Page 12
12
DAVIS WeatherLink Addendum - Page 13
13
DAVIS WeatherLink Addendum - Page 14
14
DAVIS WeatherLink Addendum - Page 15
15
DAVIS WeatherLink Addendum - Page 16
16
DAVIS WeatherLink Addendum - Page 17
17
DAVIS WeatherLink Addendum - Page 18
18
DAVIS WeatherLink Addendum - Page 19
19
DAVIS WeatherLink Addendum - Page 20
20
WeatherLink
®
for Alarm Output
Addendum
Introduction
This Streaming Data Logger is designed to provide an electrical interface
between a Vantage Pro™ or Vantage Pro2™ weather station console or
Weather Envoy™ and an electrical device. You may set a series of
thresholds for various parameters that will trigger if any of them are met (OR
condition), all of them are met (AND condition), one and only one is met
(XOR condition). You may also test whether a parameter is within (between
condition) or outside of (not between condition) a certain range, or changing
at a certain rate (trending), or how far apart (or close) two like parameters are
from each other. Finally, you may also test various parameters to see if they
are reporting a valid number. This can be used to signal a bad data
connection or malfunctioning sensor.
This product also contains the functionality of the WeatherLink for Vantage
Pro Serial version. Please consult the WeatherLink for Vantage Pro Getting
Started Guide and on-line Help files for information on the use of the
WeatherLink program (including its hardware requirements and typical
installation), package contents, and optional accessories for this product.
If you plan to install this product in a Vantage Pro or Vantage Pro2 console,
use the notch in the battery door located adjacent to where the PC connector
protrudes and above the AC power connector to bring out the Connector
Block wire.
If you plan to install this product in a Weather Envoy, it is recommended that
you knock out the left-most tab with the Weather Envoy’s PC connector
facing you and loop the Connector Block wire around the datalogger
connector to the Weather Envoy and bring it out where this tab was removed.
Hardware Installation and Requirements
In addition to the requirements for WeatherLink, the Alarm Output capability
of this product has the following additional hardware requirements.
One Free Serial Port or One Free USB port with the Serial to USB
adapter (Part # 8434) connected to a Windows PC.
Computer running any version of Windows with at least 3 MB free of
RAM and 512 KB free of hard disk space.
Small Slotted Screwdriver
1