AGA 115V Operation & Maintenance Instructions Manual

Download Assembly instruction manual of AGA 115V Kitchen Appliances for Free or View it Online on All-Guides.com.

Brand: AGA

Category: Kitchen Appliances

Type: Assembly instruction manual

Model: AGA 115V , AGA 6WCA , AGA 6WCA 115V

Pages: 12 (0.54 Mb)

Download AGA 115V Assembly instruction manual

AGA 115V Assembly instruction manual - Page 1
1
AGA 115V Assembly instruction manual - Page 2
2
AGA 115V Assembly instruction manual - Page 3
3
AGA 115V Assembly instruction manual - Page 4
4
AGA 115V Assembly instruction manual - Page 5
5
AGA 115V Assembly instruction manual - Page 6
6
AGA 115V Assembly instruction manual - Page 7
7
AGA 115V Assembly instruction manual - Page 8
8
AGA 115V Assembly instruction manual - Page 9
9
AGA 115V Assembly instruction manual - Page 10
10
AGA 115V Assembly instruction manual - Page 11
11
AGA 115V Assembly instruction manual - Page 12
12
Select Location
The proper location will ensure peak performance of your
appliance. Choose a location where the unit will be out of
direct sunlight and away from heat sources. Best
performance will be maintained when installed within the
following parameters:
A gap of 24in (606mm) is recommended between units
for moving the wine chiller. A clearance of 3in (76mm) is
required to the side of the unit that the hinges are located
on to allow for the door to open 90° degrees. Please see
diagram for recommendations for built in applications.
Cabinet Clearance
Adjacent cabinets and countertop can be installed on top,
back and sides of the unit as long as the grille and door
access remain unobstructed. Ventilation is required for the
bottom front section of the unit where the grille is located.
Keep this area open and clear of any obstructions.
Make certain that the leveling legs supplied with the wine
cooler are installed according to the instructions. Leveling
adjustments can be made by raising or lowering the glides
on the bottom of the unit.
Electrical Connection
Use nominal 115 volt, 60 cycle AC only. DO NOT USE AN
EXTENSION CORD
Grounding Method
This product is factory equipped with a power supply cord
that has a three-pronged grounded plug. It must be
plugged into a mating grounding type receptacle in
accordance with the National Electrical Code and
applicable local codes and ordinances. If the circuit does
not have a grounding type receptacle, it is the
responsibility and obligation of the customer to exchange
the existing receptacle in accordance with the National
Electrical Code and applicable local codes and ordinances.
The third ground prong should not, under any
circumstances, be cut or removed. All U.L. listed
refrigerated products are equipped with this type of plug.
Installing Your Refrigerated Wine Cooler
All specifications and product design subject to change without notice.
Such revisions do not entitle the buyer to corresponding changes, improvements,
additions, replacements or compensation for previously purchased products.
3
Ideal Ambient Temperature Range
Built-in 65° – 80°F
Free-Standing 65° – 90°F.
wall structure
adjacent cabinet
left hand swing right hand swing
3“/76mm
24” 24”
DISCONNECT POWER SOURCE BEFORE ADJUSTING
LEVELING LEGS
THIS UNIT SHOULD NOT, UNDER ANY
CIRCUMSTANCES, BE UNGROUNDED.