AGA 100 G FSD Users Manual
Download Operation & user’s manual of AGA 100 G FSD Kitchen Appliances for Free or View it Online on All-Guides.com.
Brand: AGA
Category: Kitchen Appliances
Type: Operation & user’s manual for AGA 100 G FSD
Pages: 44 (1.62 Mb)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
When servicing or replacing gas carrying components
disconnect from the gas supply before commencing
operation.
Check the appliance is gas sound after completion of
service. When checking for gas leaks do not use washing
up liquid - this can corrode. Use a product specifically
manufactured for leak detection.
CAUTION: DO NOT USE A FLAME TO CHECK FOR
GAS LEAKS.
Do not use re-conditioned or unauthorised gas controls.
Disconnect from the electricity supply before commencing
servicing, particularly before removing any of the
following:- control panel, side panels, hotplate tray or any
electrical components or covers.
Before electrical re-connection, check that the appliance
is electrically safe.
NOTE: Reference to LH and RH oven apply as viewed
from the front.
BEFORE SERVICING ANY GAS CARRYING
COMPONENTS, TURN OFF THE GAS SUPPLY.
A. To Remove Hotplate
1. Isolate from electric supply.
2. Remove pan supports and burner caps.
3. Remove burner fixing screws (14) and hotplate fixing
screws (4).
4. Lift off hotplate taking care to lift clear of burner
electrodes.
5. Re-assemble in reverse order.
B. To Remove Side Panels.
1. Isolate from electric supply.
2. Lower front mobility wheels, see section ‘MOBILITY
WHEELS’ in the users instructions.
NOTE: It may be necessary to disconnect the flexible
gas connection to allow the cooker to be withdrawn
from between the kitchen units.
3. Remove fixing screws and lift off side panel.
4. Re-assemble in reverse order.
C. To Remove Facia Castings
1. Isolate from electric supply.
2. Proceed as ‘TO REMOVE HOTPLATE’.
3. Proceed as ‘TO REMOVE SIDE PANELS’.
4. Pull off control knobs.
5. Remove control panel fixing screws 5 per casting (see
fig below). When removing screws supporting casting
when removing screws.
NOTE: When removing RH casting the oven indicator
neons require disconnecting from the facia, hold the
cables at their entry into the neon twist and pull, this
will disengage the neon assembly.
D. To Remove Timer
1. Isolate from electric supply.
2. Open top oven and grill doors to gain access to timer
facia fixing screw and remove screw.
3. The timer assembly can now be hinged upwards
sufficiently to disconnect electric cables at rear of
timer.
NOTE: Take care to identify cable connections.
34
SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished
Servicing