• Home
• Brands
• AGA Manuals
• AGA 61ARA
• AGA 61ARA 115V Operation & Maintenance Instructions Manual

AGA 61ARA 115V Operation & Maintenance Instructions Manual

Download Operation & maintenance instructions manual of AGA 61ARA Refrigerator for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

Cleaning and Maintaining Your Refrigerator

All specifications and product design subject to change without notice.

Such revisions do not entitle the buyer to corresponding changes, improvements,

additions, replacements or compensation for previously purchased products.

Condenser

The condenser tubing inside the cabinet does not require

frequent cleaning; however, satisfactory cooling depends

on adequate ventilation over the coils. Be sure that nothing

obstructs the required air flow openings in front of the

cabinet. At least once or twice a year brush or vacuum lint

and dirt from the grille. Also at least once or twice a year

brush or vacuum lint and dirt from the condenser for

efficient performance by unscrewing the grille on the

bottom front of the cabinet.

Cabinet

The painted cabinet can be washed with mild soap and

water and thoroughly rinsed with clear water. Never use

abrasive scouring powders.

Interior

Wash interior compartment with mild soap and water. Do

not use an abrasive powder, solvent, polish cleaner or

undiluted detergent.

Door Gasket

The vinyl gasket may be cleaned with mild soap and water,

a baking soda solution or a mild scouring powder.

Light Tube Replacement

WARNING! DISCONNECT THE POWER CORD BEFORE

ATTEMPTING LIGHT TUBE REPLACEMENT. Failure to do

so may result in an electrical shock that could severely

injure you.

This product uses two, 6 watt light tubes to illuminate the

interior of the refrigerator. The light tubes are very reliable

electrical components, but should either or both light

tubes not function properly, please call the dealer you

purchased your refrigerator from for replacement light

tubes. Use only original equipment light tubes from your

dealer or manufacturer.

Light tube replacement consists of using a small cross head

screwdriver to remove the two screws that hold a cover

plate over the back section of the light tube. Set the screws

and cover plate aside for re-assembly later.

Using a small flat-blade screwdriver, gently lever the front

section of the light tube down to allow it to be pulled

clear of the light housing.

Disconnect the two insulated electrical connectors from

the cabinet’s electrical cable and discard the old light tube.

Reconnect the insulated electrical connector of the new

light tube to the cabinet’s electrical cable connectors.

Make sure they are secure and fully inserted.

Carefully realign the light tube’s electrical terminals back

into the rear of the light enclosure channel making sure

not to crimp them. Gently insert the light tube along the

length of the light enclosure channel. Press the light tube

gently into the light enclosure channel. Only a small part of

the light tube should project below the ceiling of the

refrigerator. DO NOT USE A HAMMER TO FIT THE LIGHT

TUBE.

Place the light tube terminal cover plate back in its original

position on the light enclosure’s flange. Re-use the original

two screws to secure it in place. Plug the refrigerator into

the electrical socket. Check to see if the light tubes operate

properly. Your light tube’s replacement is complete.

The light tubes are not covered by your guarantee.

Replacement tubes can be obtained from your service

provider or from Aga Appliances.

7

Light Tube

Connectors

Cover Plate

Screws