Dell PowerConnect M8428-k User Manual

Download Operation & user’s manual of Dell M8428-K Chassis, Computer Accessories for Free or View it Online on All-Guides.com. This version of Dell M8428-K Manual compatible with such list of devices, as: M8428-K, PowerEdge M420, PowerEdge M520, PowerEdge M620, PowerEdge M820 Systems

Dell M8428-K Operation & user’s manual - Page 1
1
Dell M8428-K Operation & user’s manual - Page 2
2
Dell M8428-K Operation & user’s manual - Page 3
3
Dell M8428-K Operation & user’s manual - Page 4
4
Dell M8428-K Operation & user’s manual - Page 5
5
Dell M8428-K Operation & user’s manual - Page 6
6
Dell M8428-K Operation & user’s manual - Page 7
7
Dell M8428-K Operation & user’s manual - Page 8
8
Dell M8428-K Operation & user’s manual - Page 9
9
Dell M8428-K Operation & user’s manual - Page 10
10
Dell M8428-K Operation & user’s manual - Page 11
11
Dell M8428-K Operation & user’s manual - Page 12
12
Dell M8428-K Operation & user’s manual - Page 13
13
Dell M8428-K Operation & user’s manual - Page 14
14
Dell M8428-K Operation & user’s manual - Page 15
15
Dell M8428-K Operation & user’s manual - Page 16
16
Dell M8428-K Operation & user’s manual - Page 17
17
Dell M8428-K Operation & user’s manual - Page 18
18
Dell M8428-K Operation & user’s manual - Page 19
19
Dell M8428-K Operation & user’s manual - Page 20
20
Dell M8428-K Operation & user’s manual - Page 21
21
Dell M8428-K Operation & user’s manual - Page 22
22
Dell M8428-K Operation & user’s manual - Page 23
23
Rev 1.0
24
15 VccR Receiver Power Supply
16 VccT Transmitter Power Supply
17 VeeT
Transmitter Ground (Common with Receiver Ground)
a
18 TD+ Transmitter Non-Inverted DATA in. AC Coupled.
19 TD- Transmitter Inverted DATA in. AC Coupled.
20 VeeT
Transmitter Ground (Common with Receiver Ground)
a
a. Circuit ground is internally isolated from chassis ground.
b. T
FAULT
is an open collector/drain output, which should be pulled up with a 4.7k – 10k
Ohms resistor on the host board if intended for use. Pull up voltage should be between 2.0V
to Vcc + 0.3V. A high output indicates a transmitter fault caused by either the TX bias cur-
rent or the TX output power exceeding the preset alarm thresholds. A low output indicates
normal operation. In the low state, the output is pulled to <0.8V.
c. Laser output disabled on TDIS >2.0V or open, enabled on TDIS <0.8V
d. Should be pulled up with 4.7k – 10k on host board to a voltage between 2.0V and 3.6V.
MOD_ABS pulls line low to indicate module is plugged in.
e. LOS is open collector output. Should be pulled up with 4.7k – 10k on host board to a
voltage between 2.0V and 3.6V. Logic 0 indicates normal operation; logic 1 indicates loss of
signal.
Table 9 - SFP+ Pinout
Pin Symbol Name Description