Fabric OS Command Reference 165
53-1001764-02
cryptoCfg
2
- LUN number: numeric ID
- LUN type: disk or tape drive, tape medium changer, tape attached medium changer, tape
offline/unknown, or unsupported/other
- LUN serial number: The LUN serial number
- Encryption mode: encrypt or cleartext
- Encryption format: (brocade) native or DF-compatible
- Tape policy type: pool-based, LUN-based
- Encrypt existing data: disabled or enabled
- Rekey: disabled or enabled
- Key life: the key life span (in days)
- Volume/Pool label: the label for the tape volume or tape pool
- Internal EE LUN state: Encrypted, Cleartext, or Disabled (Data state is cleartext but
metadata exists on the LUN, or vice versa.)
- Encryption algorithm: AES256-ECB (DF_compatible), AES256-GCM (native) or None
(cleartext)
- Key ID state: Read, Write, or Key ID not applicable
- Key ID: The Key ID (if available)
- New LUN: Yes or No
- Replication LUN type: Primary or Mirror
- Tape session number: numeric value
- Number of uncompressed blocks: numeric value
Use the --show -container -all -cfg command for configuration information on all CryptoTarget
containers in the encryption group, or specify a crypto_target_container_name for information on a
specified CTC. The display includes the following information:
• Encryption group name: user-defined label
• Number of containers: numeric value
• For each container
- Container name: a user-defined label
- Type: tape or disk
- EE node: the node WWN
- EE slot: numeric value
- Target: target port WWN, node WWN
- VT: virtual target port WWN, node WWN
- Number of hosts: numeric value
- Configuration status: committed or defined
- For each host: the host port WWN and the node WWN
- For each VI: the virtual initiator port WWN and the node WWN
- Number of LUNs: numeric value
If a rekey session is in progress while the command is run, the following additional information is
displayed:
• LUN number: numeric ID