Fabric OS Command Reference 801
53-1001764-02
portTestShow
2
portTestShow
Displays information from portTest.
Synopsis porttestshow [-ports itemlist]
Description Use this command to display a snapshot of information from portTest. The command output
displays statistical data about past test runs and values for parameters that were set when the test
was run. Refer to the portTest help page for more information on the displayed parameters. The
output includes the following information:
Port number Displays test status for the port. Values are PASS or FAIL.
PortType Type of port tested.
PortState Current State of portTest. Values are NO TEST, TESTING, or TEST DONE.
PortTypeToTest Groups of ports tested: Values are ALL_PORTS, ALL_E_PORTS, ALL_L_PORTS,
ALL_F_PORTS, ALL_LB_PORTS, or SINGLE_PORT.
Pattern The pattern of the test packets payload.
Seed The seed value used with the selected pattern. The default seed value is
0xaa.
UserDelay The delay between frames sent by portTest in milliseconds. The default value
is 10 milliseconds.
TotalIteration Total number of test iterations.
CurrentIteration Current test iteration.
TotalFail Total number of failed tests.
ConsecutiveFail Number of consecutive failed tests.
StartTime portTest start time.
StopTime portTest end time.
Timeout Number of timed out tests.
ErrorCode Error code, if any.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operand:
-ports itemlist Displays test results for the specified ports. This operand is optional; if
omitted, data for all ports are displayed. Refer to the itemList help page for
further details.