438 Fabric OS Message Reference
53-1001767-01
MS-1009
69
MS-1009
Message <timestamp>, [MS-1009], <sequence-number>,, ERROR, <system-name>, RLIR event.
Switch Port ID is <port number> (<PID (hex)>). Device Port Tag is <port tag>.
<message text>.
Probable Cause Indicates a registered link incident record (RLIR) has been generated for one of the actions
indicated by the <message>.
The following messages will be displayed:
• Exceeded bit error rate threshold
• Loss of signal or synchronization
• Not operational seq. recognized
• Primitive sequence timeout
• Unrecognized link incident
Recommended
Action
Persistent RLIR incidents are likely the result of SAN hardware problems such as bad cables or
small form-factor pluggables (SFPs). It may be necessary to replace hardware if these messages
persist.
Severity ERROR
MS-1021
Message <timestamp>, [MS-1021], <sequence-number>,, ERROR, <system-name>, MS WARMBOOT
failure(FSS_MS_WARMINIT failed. Reason=<failure reason>).
Probable Cause Indicates the Fabric OS state synchronization (FSS) warm recovery failed during the WARM INIT
phase of a reboot.
Recommended
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
MS-1022
Message <timestamp>, [MS-1022], <sequence-number>,, INFO, <system-name>, Management
Server Platform Service <Activated or Deactivated>.
Probable Cause Indicates Management Server Platform Service is being activated or deactivated.
Recommended
Action
No action is required.
Severity INFO