Fabric OS v6.4.1 Release Notes v1.0 Page 19 of 62
Power Supply Requirements for B
Power Supply Requirements for BPower Supply Requirements for B
Power Supply Requirements for Blades in 48k and DCX/DCX
lades in 48k and DCX/DCXlades in 48k and DCX/DCX
lades in 48k and DCX/DCX-
--
-4S Chassis
4S Chassis4S Chassis
4S Chassis
Type of
Type of Type of
Type of
@200-240
VAC
(Redundant
configurations)
DCX/DCX
DCX/DCXDCX/DCX
DCX/DCX
@110 VAC
(Redundant
configurations)
DCX/DCX
DCX/DCXDCX/DCX
DCX/DCX
@200-240 VAC
(Redundant
configurations)
Comments
CommentsComments
Comments
configuration with any
number of FS8-18
Blades.
• For both DCX and
DCX-4S with FX8-24
blades, (1+1) 220VAC
Power Supplies are
required for
redundancy.
FOS Feature Compatibility in Native Connectivity Modes
FOS Feature Compatibility in Native Connectivity ModesFOS Feature Compatibility in Native Connectivity Modes
FOS Feature Compatibility in Native Connectivity Modes
Some FOS features are not fully supported when operating in the native connectivity modes for deployment
with M-EOS based products. All Brocade models that are supported by Fabric OS v6.4 support both
interopmodes 2 and 3 with the exception of the Brocade 4100 and 8000 and DCX/DCX-4S with one or more
FCOE10-24 blades.
The following table specifies the support of various FOS features when operating in either interopmode 2
(McDATA Fabric Mode) or interopmode 3 (Open Fabric Mode) with Fabric OS v6.4
.
FOS Features
FOS Features FOS Features
FOS Features
(supported in interopmode 0)
FOS v6.4
FOS v6.4FOS v6.4
FOS v6.4
IM = Interopmode
IM = InteropmodeIM = Interopmode
IM = Interopmode
Frame Redirection (devices attached to FOS)
Frame Redirection (devices attached to M
Frame Redirection over FCR
Fabric Binding (route to M
EOS fabric with Fabric binding)
Dynamic Path Selection (DPS, exchange based
Dynamic Load Sharing (DLS, port based routing)
Virtual Channels (VC RDY)
FICON Management Server (Cascading)
Full Scalability (to maximum M
