Home | About | Contact

Dell 8 Update Manual

Download Update manual of Dell PowerEdge M1000e Desktop, Network Card for Free or View it Online on All-Guides.com. This version of Dell PowerEdge M1000e Manual compatible with such list of devices, as: 8, PowerEdge M610x, PowerEdge M710, PowerEdge M710HD, 2970

Dell PowerEdge M1000e Update manual - Page 1
1
Dell PowerEdge M1000e Update manual - Page 2
2
Dell PowerEdge M1000e Update manual - Page 3
3
Dell PowerEdge M1000e Update manual - Page 4
4
Dell PowerEdge M1000e Update manual - Page 5
5
Dell PowerEdge M1000e Update manual - Page 6
6
Dell PowerEdge M1000e Update manual - Page 7
7
Dell PowerEdge M1000e Update manual - Page 8
8
Dell PowerEdge M1000e Update manual - Page 9
9
Dell PowerEdge M1000e Update manual - Page 10
10
Dell PowerEdge M1000e Update manual - Page 11
11
Dell PowerEdge M1000e Update manual - Page 12
12
Dell PowerEdge M1000e Update manual - Page 13
13
Dell PowerEdge M1000e Update manual - Page 14
14
AMD™ Processor Update
HT Assist
AMD Opteron™ 24XX and 84XX processors enabled with HT Assist feature
allow faster HyperTransport™ (HT) transfers. However, when enabled,
HT Assist reduces the L3 cache size from 6 MB to 5 MB.
System reboot after enabling HT Assist reports the reduced L3 cache size
and continues to do so until disabled. The HT Assist feature can be enabled
or disabled using your system's BIOS settings.
For information on accessing BIOS settings, see your system's Hardware Owner's
Manual on the Dell Support website at www.support.dell.com/manuals.
HyperTransport Technology
Depending on your system capability, you can set your system’s HyperTransport
mode to HT3.
Your system and/or processors may or may not be HT3 capable, depending on
when it was shipped. HT3 technology was added to selected Dell systems in early
2009 and HT3 processors became available in May 2009.
During system startup, the system BIOS checks the system board revision
number and the HT capability of all installed processors. If the system is capable
of running at HT3 frequency, the HyperTransport Technology field in the BIOS
settings is set to HT3 by default. You can then set the field to either HT1 or
HT3, depending on which setting gives you the best performance for your
particular application.
If your system is not HT3 capable, this field is set to HT1 and read only.
July 2009