Dell PowerEdge 2300 Upgrade Manual

Download Upgrade manual of Dell 4300 Computer Hardware, Desktop for Free or View it Online on All-Guides.com.

Brand: Dell

Category: Computer Hardware , Desktop , Projector , Server , Wireless Router

Type: Upgrade manual

Model: Dell 4300 , Dell 2300 , Dell PowerEdge 4350

Pages: 24 (1.14 Mb)

Download Dell 4300 Upgrade manual

Dell 4300 Upgrade manual - Page 1
1
Dell 4300 Upgrade manual - Page 2
2
Dell 4300 Upgrade manual - Page 3
3
Dell 4300 Upgrade manual - Page 4
4
Dell 4300 Upgrade manual - Page 5
5
Dell 4300 Upgrade manual - Page 6
6
Dell 4300 Upgrade manual - Page 7
7
Dell 4300 Upgrade manual - Page 8
8
Dell 4300 Upgrade manual - Page 9
9
Dell 4300 Upgrade manual - Page 10
10
Dell 4300 Upgrade manual - Page 11
11
Dell 4300 Upgrade manual - Page 12
12
Dell 4300 Upgrade manual - Page 13
13
Dell 4300 Upgrade manual - Page 14
14
Dell 4300 Upgrade manual - Page 15
15
Dell 4300 Upgrade manual - Page 16
16
Dell 4300 Upgrade manual - Page 17
17
Dell 4300 Upgrade manual - Page 18
18
Dell 4300 Upgrade manual - Page 19
19
Dell 4300 Upgrade manual - Page 20
20
Dell 4300 Upgrade manual - Page 21
21
Dell 4300 Upgrade manual - Page 22
22
Dell 4300 Upgrade manual - Page 23
23
Dell 4300 Upgrade manual - Page 24
24
support.dell.com Dell PowerEdge Systems Microprocessor Upgrade 1-13
 ! 
!"#!$
%
To remove the guide bracket assembly, perform the following steps:
1. Remove any terminator card installed in the guide bracket.
2. Remove any microprocessor assembly installed in the guide bracket.
3. Use a #2 Phillips screwdriver to loosen the four captive nuts that secure the
guide bracket assembly to the system board (see Figure 1-5).
4. Lift up the assembly to remove it from the four threaded posts.
To install the new guide bracket assembly, perform the following steps:
1. Position the guide bracket over the four threaded posts (see Figure 1-6).
You can install the guide bracket only one way (the captive nuts will not align
with the threaded posts if installed incorrectly).
2. Tighten the four captive nuts using a #2 Phillips screwdriver.
release latches (2)
thumbscrews (2)
heat sink
microprocessor