Dell Studio 1535 Service Manual
Download Service manual of Dell 1535 - Studio Core 2 Duo T8100 2.10GHz 4GB 320GB Desktop, Laptop for Free or View it Online on All-Guides.com.
Brand: Dell
Type: Service manual
Model: Dell 1535 - Studio Core 2 Duo T8100 2.10GHz 4GB 320GB , Dell Studio 1536 , Dell Studio 1537
Pages: 41 (1.12 Mb)
Download Dell 1535 - Studio Core 2 Duo T8100 2.10GHz 4GB 320GB Service manual
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
Back to Contents Page
Processor Module
Dell™Studio1535/1536ServiceManual
Removing the Processor Module
1. Follow the instructions in Before You Begin.
2. Remove the processor thermal-cooling assembly (see Removing the Processor Thermal-Cooling Assembly).
3. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.
4. Lift the processor module from the ZIF socket.
Replacing the Processor Module
1. Follow the instructions in Before You Begin.
2. Align the pin-1 corner of the processor module with the pin-1 corner of the ZIF socket, then insert the processor module.
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
NOTICE: To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.
1
ZIF-socket cam screw
2
ZIF socket
NOTICE: To ensure maximum cooling for the processor, do not touch the heat transfer areas on the processor thermal-cooling assembly. The oils in
your skin can reduce the heat transfer capability of the thermal pads.
NOTICE: When removing the processor module, pull the module straight up. Be careful not to bend the pins on the processor module.
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
NOTICE: Do not touch the processor die. Press and hold the processor down on the substrate on which the die is mounted while turning the cam screw
to prevent intermittent contact between the cam screw and processor.
NOTICE: Ensure that the cam lock is in the fully open position before seating the processor module. Seating the processor module properly in the ZIF
socket does not require force. A processor module that is not properly seated can result in an intermittent connection or permanent damage to the
microprocessor and ZIF socket.
NOTE: If a new processor is installed, you will receive a new thermal-cooling assembly, which will include an affixed thermal pad, or you will receive a
new thermal pad along with documentation to illustrate proper installation.