• Home
• Brands
• Dell Manuals
• Dell 1535 - Studio Core 2 Duo T8100 2.10GHz 4GB 320GB
• Dell Studio 1535 Service Manual

Dell Studio 1535 Service Manual

Download Service manual of Dell 1535 - Studio Core 2 Duo T8100 2.10GHz 4GB 320GB Desktop, Laptop for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

30

31

32

33

34

35

36

37

38

39

40

41

Back to Contents Page

 Memory

Dell™Studio1535/1536ServiceManual



You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Quick Reference Guide for information

on the memory supported by your computer. Install only memory modules that are intended for your computer.

Your computer has two user-accessible SODIMM sockets, DIMM A and DIMM B, accessed from the bottom of the computer.



Removing Memory Module(s)

The memory modules are located under the base cover on the computer.



1. Follow the procedures in Before You Begin.



2. Turn the computer over and remove the base cover (see Removing the Base Cover).



3. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.



4. Remove the module from the connector.



Replacing Memory Module(s)



1. Align the notch in the module edge connector with the tab in the connector slot.



2. Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not hear the click, remove the

module and reinstall it.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.

NOTE: MemorymodulespurchasedfromDell™arecoveredunderyourcomputerwarranty.

NOTICE: If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMM A" before you install a

module in the connector labeled "DIMM B."

NOTICE: To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such

as a connector on the back of the computer).

1

securing clips (2)

2

memory module

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such

as a connector on the back of the computer).

NOTE: If the memory module is not installed properly, the computer may not boot. No error message indicates this failure.