Dell Dimension 2100 System Reference Manual
Download System reference manual of Dell Latitude 2100 Desktop, Laptop for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Desktop , Laptop , Server
Type: System reference manual for Dell Latitude 2100
Pages: 70 (0.9 Mb)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
9. Push the system-board retaining clip until it disengages.
10. Slide the system board forward until is no longer held by the
standoffs that secure the system board to the computer frame.
NOTE: You may need to slide the board toward the front of the computer to clear
the hooked standoffs before you can lift the board from the computer.
11. Carefully lift the system board out of the input/output (I/O) gasket
and remove the board from the computer. The I/O gasket is on the back
of the computer where all of the input and output ports are located (see
the
system board
).
When you install a replacement
system board
, angle the back of the board
downward and carefully align the connectors on the back edge of the board
with the cutouts in the I/O gasket. When properly aligned, the board
connectors slide into the I/O gasket as you lower the board into position in the
chassis and reseat it on the standoffs. Lock the board in place with the
system-board retaining clip.
After you install the replacement system board, replace the
microprocessor
,
the
heat sink
, the
memory modules
, and the
cards
that you removed from the old
system board.
To configure the system after you install a replacement board:
1. Install the jumper plug on pins 2 and 3 of
configuration jumper
J7A1 to
select Maintenance mode operation.
2.
Replace the computer cover
, and start the computer.
The computer automatically starts the
system setup program
, adds
the Maintenance option to the menu bar, and displays
the Maintenance screen.
3. Select Clear All Passwords, and press <Enter> twice.
4. Press <F10> to exit the system setup program and save any changes
you made.