Dell PowerConnect M6348 Configuration Manual
Download Configuration manual of Dell PowerEdge M520 Computer Hardware, Desktop for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Computer Hardware , Desktop , Network Hardware , Network Router , Server , Switch
Type: Configuration manual
Model: Dell PowerEdge M520 , Dell PowerEdge M820 Systems , Dell PowerConnect M6348
Pages: 158 (1.54 Mb)
Device Security 105
Example 2: Show MAB Configuration
To show the MAB configuration for interface 1/5, use the following command:
console#show dot1x ethernet 1/g5
Administrative Mode............... Enabled
Port Admin Oper Reauth Reauth
Mode Mode Control Period
------- ------------------ ------------ -------- ----------
1/g5 mac-based Authorized TRUE 300
Quiet Period................................... 60
Transmit Period................................ 30
Maximum Requests............................... 2
Max Users...................................... 16
Supplicant Timeout............................. 30
Server Timeout (secs).......................... 30
MAB mode (configured).......................... Enabled
MAB mode (operational)......................... Enabled
Logical Supplicant AuthPAE Backend VLAN Username Filter
Port MAC-Address State State Id Id
------- ----------------- ------------ ----------- ----- -------- --------
64 0012.43D1.D19F Authenticated Idle 1
Authentication Server Filter Assignment
The
PowerConnect M6220/M6348/M8024
switches
allow the external 802.1X Authenticator or RADIUS
server to assign DiffServ policies to users that authenticate to the switch. When a host (supplicant)
attempts to connect to the network through a port, the switch contacts the 802.1X authenticator or
RADIUS server, which then provides information to the switch about which DiffServ policy to assign the
host (supplicant). The application of the policy is applied to the host after the authentication process has
completed.
To enable filter assignment by an external server, the following conditions must be true:
1
The port that the host is connected to must be enabled for MAC-based port access control by using
the following command in Interface Config mode:
dot1x port-control mac-based
2
The RADIUS or 802.1X server must specify the policy to assign.
For example, if the DiffServ policy to assign is named internet_access, include the following attribute
in the RADIUS or 802.1X server configuration: