Dell PowerConnect M6348 Configuration Manual
Download Configuration manual of Dell PowerEdge M520 Computer Hardware, Desktop for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Computer Hardware , Desktop , Network Hardware , Network Router , Server , Switch
Type: Configuration manual
Model: Dell PowerEdge M520 , Dell PowerEdge M820 Systems , Dell PowerConnect M6348
Pages: 158 (1.54 Mb)
Device Security 99
IP address Type Port TimeOut Retran. DeadTime Source IP Prio. Usage
------------- ----- ----- ------- ------- -------- ------------- ----- -----
10.27.5.157 Auth 1812 Global Global Global 10.27.65.13 0 all
Global values
Configured Authentication Servers : 1
Configured Accounting Servers : 0
Named Authentication Server Groups : 1
Named Accounting Server Groups : 0
Timeout : 3
Retransmit : 3
Deadtime : 0
Source IP : 0.0.0.0
RADIUS Attribute 4 Mode : Disable
RADIUS Attribute 4 Value : 0.0.0.0
console(config)#aaa authentication login radiusList radius
console(config)#aaa authentication dot1x default radius
console(config)#dot1x system-auth-control
console(config)#interface ethernet 1/g1
console(config-if-1/g1)#dot1x port-control force-authorized
console(config-if-1/g1)#exit
Example #2: MAC-Based Authentication Mode
The PowerConnect M6220/M6348/M8024 switches support MAC-based 802.1X authentication. This
feature allows multiple hosts to authenticate on a single port. The hosts are distinguished by their MAC
addresses.
When multiple hosts (for example, a PC, a printer, and a phone in the same office) are connected to the
switch on the same port, each of the connected hosts authenticates separately with the RADIUS server.
The following command enables MAC-based authentication on port 1/g8 and limits the number of
devices that can authenticate on that port to 3. The switchport mode general command sets the
port to allow multiple VLANs to participate in the port. The port must be in general mode in order to
enable MAC-based 802.1X authentication.
console#configure
console(config)#interface ethernet 1/g8
console(config-if-1/g8)#switchport mode general
console(config-if-1/g8)#dot1x port-control mac-based
console(config-if-1/g8)#dot1x max-users 3
console(config-if-1/g8)#exit
console(config)#exit
console#show dot1x ethernet 1/g8