150 Script Commands
Clear Storage Array Configuration
Use this command to:
• Clear the entire storage array configuration, and return it back to the
initial installation state.
• Clear the configuration except for security information and identification
• Clear disk group configuration information and virtual disk configuration
CAUTION: As soon as you run this command, the existing storage array is
clear storageArray configuration (all |
If you do not enter a parameter, this command removes all configuration
information for the storage array, except for the information related to
security and identification.
NOTE: When you run this command, the storage array becomes unresponsive, and
all script processing is cancelled. You must remove and re-add the storage array to
resume communication with the host. To remove an unresponsive storage array,
access the Enterprise Management Window, and click Edit Remove. To re-add
the storage array, access the Enterprise Management Window, click Edit Add
Storage Array, and enter the appropriate IP addresses.
all The setting to remove the entire configuration of
the storage array, including security and identity
information. Removing all configuration
information returns the storage array to its initial
diskGroups The setting to remove the virtual disk
configuration and the disk group configuration.
The rest of the configuration stays intact.
book.book Page 150 Wednesday, June 8, 2011 12:20 PM