190 Script Commands
Diagnose RAID Controller Module
This command runs diagnostic tests on the RAID controller module.
The testID parameter takes the following options, which you can use to verify
that a RAID controller module is functioning correctly:
— Reads the test
— Performs a data loop-back test
— Writes the test
The diagnostic tests consist of loop-back tests in which data is written to
physical disks and read from the physical disks.
allVirtualDisks Deletes all virtual disks in a storage array.
NOTE: Using the
deletes virtual disks until all are removed or
until an error is encountered. If an error is
encountered, this command does not attempt
to delete the remaining virtual disks.
virtualDisk or virtualDisks Name of the virtual disk to delete. You
can enter more than one virtual disk
name. You must put brackets ([ ]) around
the virtual disk name. If the virtual disk
name has special characters, you must
also put quotation marks (" ") around the
virtual disk name.
Deleting the last virtual disk in a disk
group does not delete the disk group. You
can have a standalone disk group (minus
any virtual disks). To remove the
standalone disk group, set this parameter
to TRUE. To keep standalone disk groups
intact, set this parameter to FALSE.
book.book Page 190 Wednesday, June 8, 2011 12:20 PM