Script Commands 219
Revive Physical Disk
This command forces the specified physical disk to the optimal state.
CAUTION: Correct use of this command depends on the data configuration on all
physical disks in the disk group. Never attempt to revive a physical disk unless
supervised by a Technical Support representative.
revive physicalDisk [enclosureID,slotID]
Save Enclosure Log Data
This command saves the enclosure log sense data to a file. Log sense data is
maintained by the environmental cards for each enclosure. Not all of the
environmental cards contain log sense data.
save allEnclosures logFile="filename"
physicalDisk Identifies the enclosure and slot where, the physical disk
resides. Enclosure ID values are 0 to 99. Slot ID values are 0
to 31. You must put brackets ([ ]) around the enclosure ID
value and the slot ID value.
logFile Name of the file to which to save the log sense data. You
must put quotation marks (" ") around the file name.
book.book Page 219 Wednesday, June 8, 2011 12:20 PM