28 About the Command Line Interface
8 The storage array name was not in the configuration file.
10 A management class does not exist for the storage array.
11 A storage array was not found in the configuration file.
12 An internal error occurred.
13 Invalid script syntax was found.
14 The RAID controller module was unable to communicate with the
15 A duplicate argument was entered.
16 An execution error occurred.
17 A host was not at the specified address.
18 The World Wide Identifier (WWID) was not in the
19 The WWID was not at the address.
20 An unknown IP address was specified.
21 The event monitor configuration file was corrupted.
22 The storage array was unable to communicate with the event monitor.
23 The RAID controller module was unable to write alert settings.
24 The wrong management station was specified.
25 The command was not available.
26 The device was not in the configuration file.
27 An error occurred while updating the configuration file.
28 An unknown host error occurred.
29 The sender contact information file was not found.
30 The sender contact information file could not be read.
31 The userdata.txt file exists.
32 An invalid -I value in the e-mail alert notification was specified.
33 An invalid -f value in the e-mail alert notification was specified.
Table 1-3. Exit Status
Status Value Meaning
book.book Page 28 Wednesday, June 8, 2011 12:20 PM