Dell PowerVault 3000i System Installation Manual
Download System installation manual of Dell PowerVault MD3000i Enclosure, Network Storage Server for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Enclosure , Network Storage Server , Server , Software , Speaker System , Storage
Type: System installation manual
Model: Dell PowerVault MD3000i , Dell PowerVault 3000i
Pages: 68 (0.57 Mb)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
54 Setting Up Your iSCSI Storage Array
Step 7: Connect to the Target Storage Array from the Host Server
If you are using Windows Server 2003 or Windows Server 2008 GUI
1
Click
Start
→
Programs
→
Microsoft iSCSI Initiator
or
Start
→
All Programs
→
Administrative
Tools
→
iSCSI Initiator
.
2
Click the
Targets
tab.
If previous target discovery was successful, the
iqn
of the storage array should be displayed under
Targets
.
3
Click
Log On
.
4
Select
Automatically restore this connection when the system boots
.
5
Select
Enable multi-path
.
6
Click
Advanced
and configure the following settings under the
General
tab:
•
Local Adapter
: Must be set to
Microsoft iSCSI Initiator
.
•
Source IP
: The source IP address of the host server you want to connect from.
•
Target Portal
: Select the iSCSI port on the storage array controller that you want to
connect to.
•
Data Digest and Header Digest
: Optionally, you can specify that a digest of data or header
information be compiled during transmission to assist in troubleshooting.
•
CHAP logon information
: If CHAP authentication is required, select this option and enter
the
Target secret
.
•
Perform mutual authentication
: If mutual CHAP authentication is configured, select this
option.
NOTE: IPSec is not supported.
7
Click
OK
.
To support storage array controller failover, the host server must be connected to at least one iSCSI
port on each controller. Repeat step 3 through step 8 for each iSCSI port on the storage array that you
want to establish as failover targets (the
Target Portal
address will be different for each port you
connected to).
NOTE: To enable the higher throughput of multipathing I/O, the host server must connect to both iSCSI ports
on each controller, ideally from separate host-side NICs. Repeat step 3 through step 7 for each iSCSI port on
each controller. If using a duplex MD3000i configuration, then LUNs should also be balanced between the
controllers.
The
Status
field on the
Ta rg et s
tab should now display as
Connected
.
8
Click
OK
to close the Microsoft iSCSI initiator.
NOTE: MD3000i supports only round robin load-balancing policies.