Dell PowerVault 3000i System Installation Manual
Download System installation manual of Dell PowerVault MD3000i Enclosure, Network Storage Server for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Enclosure , Network Storage Server , Server , Software , Speaker System , Storage
Type: System installation manual
Model: Dell PowerVault MD3000i , Dell PowerVault 3000i
Pages: 68 (0.57 Mb)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
64 Network Configuration Guidelines
4
Select
Use the following IP address
and enter the IP address, subnet mask, and default gateway
addresses.
If using a DNS server
1
On the
Control Panel
, select
Network connections
or
Network and Sharing Center
. Then click
Manage network connections
.
2
Right-click the network connection you want to configure and select
Properties
.
3
On the
General
tab (for a local area connection) or the
Networking
tab (for all other connections),
select
Internet Protocol (TCP/IP)
, and then click
Properties
.
4
Select
Obtain DNS server address automatically
or enter the preferred and alternate DNS server IP
addresses and click
OK
.
If using a WINS server
NOTE: If you are using a DHCP server to allocate WINS server IP addresses, you do not need to add WINS
server addresses.
1
On the
Control Panel
, select
Network connections
.
2
Right-click the network connection you want to configure and select
Properties
.
3
On the
General
tab (for a local area connection) or the
Networking
tab (for all other connections),
select
Internet Protocol (TCP/IP)
, and then click
Properties
.
4
Select
Advanced
, then the
WINS
tab, and click
Add
.
5
In the
TCP/IP WINS server
window, type the IP address of the WINS server and click
Add
.
6
To enable use of the
Lmhosts
file to resolve remote NetBIOS names, select
Enable LMHOSTS
lookup
.
7
To specify the location of the file that you want to import into the
Lmhosts
file, select
Import
LMHOSTS
and then select the file in the
Open
dialog box
8
Enable or disable NetBIOS over TCP/IP.
If using Windows 2008 Core Version
On a server running Windows 2008 Core version, use the netsh interface command to configure the
iSCSI ports on the host server.
Linux Host Setup
If you are using a Linux host network, the following section provides a framework for preparing your
network for iSCSI.
To set up a Linux host network, you must configure the IP address and netmask of each iSCSI port
connected to the storage array. The specific steps depend on whether you are configuring TCP/IP using
Dynamic Host Configuration Protocol (DHCP) or configuring TCP/IP using a static IP address.