Dell W2600 - 26" LCD TV Notice
Download Notice of Dell W2600 - 26" LCD TV Flat Panel TV, TV for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Flat Panel TV , TV
Type: Notice for Dell W2600 - 26" LCD TV
Pages: 149 (17.91 Mb)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
Troubleshooting Your TV 41
No audio 1
Ensure the green audio cable is connected to
audio connector on the TV and on the computer.
For the location of the connector on the TV see,
"Using VGA (PC Analog)." on page 19." See your
computer documentation for the location of
connectors on your computer.
Do not connect the audio cable to the headphone
jack.
2
Ensure the volume on the computer is not muted.
3
Verify that sound on your computer is working by
checking the speakers. See your computer
documentation for information on
troubleshooting your computer.
4
Disconnect the TV from the computer and test to
see if the TV volume works.
PIP/POP/PBP not working 1
Ensure the settings in the OSD are properly set.
Press
Menu
to enter the OSD, and select
PIP/POP/PBP
.
2
Swap the video and audio source.
No video NOTE: If you see a self-test, it means there is a
problem with your video card or you are using the
wrong input source.
1
Ensure the TV is turned on.
2
Verify that all the cables are properly connected to
the TV, including the power cable.
3
Check to see if there is a blue or amber light on
the lower, right-hand corner of the TV. A blue light
indicates the TV is on. An amber light, means the
TV is in power save mode.
4
Ensure
PC Analog
is selected in the
Input Source
menu. See "Input Select Menu" on page 26 for
more information.
5
Reconnect the computer.
6
Connect another device that you know is working
properly.
7
Reset the original factory defaults. Press
Menu
on
the remote control, select
Setup
, and then select
Factory Reset
.
Problem Possible Solution
W2600e0.book Page 41 Wednesday, June 30, 2004 11:55 PM