Dell Metered Rack Power Distribution Unit User's Manual
Download Operation & user’s manual of Dell Metered Rack Power Distribution Unit Power distribution unit for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Power distribution unit
Type: Operation & user’s manual for Dell Metered Rack Power Distribution Unit
Pages: 90 (1.09 Mb)
Download Dell Metered Rack Power Distribution Unit Operation & user’s manual
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
55
Serial Interface Operation
|
Configuring the Network without a DHCP Server
To configure a network without a DHCP server:
1 In the HyperTerminal session window, enter admin at the User prompt, then enter admin at the password
prompt.
2 Type 2 to select Network Settings and press Enter . The Network Settings menu displays (see the following
example).
---------------------------------------------------------
---------------- Network Settings -----------------------
---------------------------------------------------------
1. Read NetworkSettings
2. Modify Network Settings
3. Set Ethernet Speed
0. Exit
Select an option ==> 2
3 At the Select an option prompt, type 2 to configure the network settings manually and press Enter. The
screen displays a series of questions (see the following example).
For each of the following questions, you can press <Return> to select
the value shown in braces, or you can enter a new value.
Should this target obtain IP settings from the network?[N] N
Static IP address [166.99.1.2]? 166.99.21.21
Static IP address is 166.99.21.21
Subnet Mask IP address [255.255.248.0]? 255.255.255.0
Subnet Mask IP address is 255.255.255.0
Gateway address IP address [166.99.17.1]? 166.99.17.1
Gateway address IP address is 166.99.17.1
Wait while your new configuration is saved.
Reset the card to enable the new configuration.
4 Follow the directions to respond to the questions displayed:
Required. Enter the static IP parameters (for IPV4 only).
For all other questions displayed, press Enter to accept the default value (shown in braces), or enter an new
value.
5 When Done displays, type 0 and press Enter to exit.
6 Type 1 and press Enter, then type 2 and press Enter to restart the NMC. The NMC restarts with the new
IP settings in approximately one minute.
7 Network configuration is completed.
NOTE:
See Page 56 though Page 64 for an alphabetical command listing of detailed syntax, query options, and example
responses.