Dell 3010CN Service Manual
Download Service manual of Dell 3010cn - Color Laser Printer Printer for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Printer
Type: Service manual for Dell 3010cn - Color Laser Printer
Pages: 638 (28.93 Mb)
3 - 197
Chapter 3 Removal and Replacement Procedures (RRPs)
RRP6.4 2ND BTR ASSY (PL 6.1.10)
[Removal]
1) Open COVER FRONT-U (PL 1.1.14).
2) Open TOP COVER (PL 1.1.1).
3) Remove IBT (PL 7.1.1).
When carrying out the work shown below, push LATCH ROTARY (PL 9.1.3) of
DEVELOPER LATCH ASSEMBLY (PL 9.1.1) to release the latch, turn DEVELOPER
ROTOR FRAME ASSEMBLY(PL 9.2.9) manually, move HOUSING ASSY-DEVE, and
avoid your hand or arm being stained by the toner of MAG ROLL.
4) Turn the lever on both left and right sides of 2ND BTR ASSY (PL 6.1.10) toward you, and
release the lever lock from BIAS TRANSFER ROLL(BTR) FRAME ASSEMBLY (PL 6.1.5).
5) Hold lever of 2ND BTR ASSY and pull out the right side of 2ND BTR ASSY from BIAS
TRANSFER ROLL(BTR) FRAME ASSEMBLY, pull out the left side and remove 2ND BTR
ASSY from the main unit.
[Replacement]
When carrying out the work shown below, push LATCH ROTARY (PL 9.1.3) of
DEVELOPER LATCH ASSEMBLY (PL 9.1.1) to release the latch, turn DEVELOPER
ROTOR FRAME ASSEMBLY(PL 9.2.9) manually, move HOUSING ASSY-DEVE, and
avoid your hand or arm being stained by the toner of MAG ROLL.
When carrying out the work shown below, make sure to place the right side shaft section
of 2ND BTR ASSY underneath the terminal section of PLATE BIAS-2ND ASSY (PL
6.1.23).
1) After placing the left side gear of 2ND BTR ASSY (PL 6.1.10) to the main unit, engage the
right and left bearings of 2ND BTR ASSY with BIAS TRANSFER ROLL(BTR) FRAME
ASSEMBLY (PL 6.1.5) and attach it.
After attaching 2ND BTR ASSY, make sure that the levers located at both left and right
move smoothly up and down.
2) Turn the levers located at both left and right of 2ND BTR ASSY downward, and lock the
levers to BIAS TRANSFER ROLL(BTR) FRAME ASSEMBLY.
3) Attach IBT (PL 7.1.1).
4) Close TOP COVER (PL 1.1.1).
5) Close COVER FRONT-U (PL 1.1.14).