Dell Catalyst 3130 Command Reference Manual
Download Command reference manual of Dell 3130 Color Laser Printer, Switch for Free or View it Online on All-Guides.com.
Brand: Dell
Type: Command reference manual
Model: Dell 3130 Color Laser , Dell Catalyst 3032
Pages: 1082 (21.4 Mb)
2-148
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
dot1x violation-mode
dot1x violation-mode
Use the dot1x violation-mode interface configuration command on the switch stack or on a standalone
switch to configure the violation modes that occur when a new device connects to a port or when a new
device connects to a port after the maximum number of devices are connected to that port.
dot1x violation-mode {shutdown | restrict | protect}
no dot1x violation-mode
Syntax Description
Defaults By default, dot1x violation-mode protect is enabled.
Command Modes Interface configuration
Command History
Examples This example shows how to configure an IEEE 802.1x-enabled port as error disabled and to shut down
when a new device connects to the port:
Switch(config-if)# dot1x violation-mode shutdown
This example shows how to configure an IEEE 802.1x-enabled port to generate a system error message
and change the port to restricted mode when a new device connects to the port:
Switch(config-if)# dot1x violation-mode restrict
This example shows how to configure an IEEE 802.1x-enabled port to ignore a new connected device
when it is connected to the port:
Switch(config-if)# dot1x violation-mode protect
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
shutdown Error disables the port or the virtual port on which a new unexpected MAC
address occurs.
restrict Generates a syslog error when a violation error occurs.
protect Silently discards packets from any new MAC addresses. This is the default
setting.
Release Modification
12.2(46)SE This command was introduced.