Dell PowerEdge 1855 Quick Start Manual

Download Quick start manual of Dell 1855 Server, Switch for Free or View it Online on All-Guides.com.

Brand: Dell

Category: Server , Switch

Type: Quick start manual

Model: Dell 1855 , Dell 1955

Pages: 12 (0.45 Mb)

Download Dell 1855 Quick start manual

Dell 1855 Quick start manual - Page 1
1
Dell 1855 Quick start manual - Page 2
2
Dell 1855 Quick start manual - Page 3
3
Dell 1855 Quick start manual - Page 4
4
Dell 1855 Quick start manual - Page 5
5
Dell 1855 Quick start manual - Page 6
6
Dell 1855 Quick start manual - Page 7
7
Dell 1855 Quick start manual - Page 8
8
Dell 1855 Quick start manual - Page 9
9
Dell 1855 Quick start manual - Page 10
10
Dell 1855 Quick start manual - Page 11
11
Dell 1855 Quick start manual - Page 12
12
8 of 12 SilkWorm 4016 Quickstart Guide
Publication Number: Publication Number: 53-100051-01
This locks the SilkWorm 4016 into the chassis I/O bay and activates the connection with the DRAC/MC via the
backplane connectors. Locking the SilkWorm 4016 into the bay activates the switch and switch LEDs.
7. If necessary, install an SFP module.
Refer to the SFP manufacturers documentation for details about SFP modules.
After it is activated, the switch runs self-diagnostic tests (such as POST). After the diagnostics have completed, cable the
SilkWorm 4016 as directed by the Dell PowerEdge 1855 documentation. The DRAC/MC creates a connection to the
switch for configuration. Use the DRAC/MC to configure the switch’s Ethernet IP address.
Refer to the Dell PowerEdge 1855 documentation for details.
Configuring the Brocade SilkWorm 4016
The SilkWorm 4016 must be configured correctly before it can operate within a network and fabric. Before beginning,
make sure that you have the following:
The SilkWorm 4016 installed in a PowerEdge 1855 chassis
A workstation computer with a terminal emulator (such as HyperTerminal)
An unused IP address and corresponding subnet mask and gateway address
A serial cable to connect to the PowerEdge 1855 chassis
SFP transceivers and compatible fibre cables, as required
Access to an FTP server for backing up the switch configuration
Caution
Do not connect the switch to the network until the IP address is correctly set. For instructions on how to set the
IP address, see Set the Switch IP Address.
scale: 3/8" = 1"
80-00
0
17
1
8
-
0
1
R
ev.
B
R
Q
04000
0
1
3
3
MA
C
0
0
0
51E3
4
7
02
9
W
W
N1
0
:0
0
:
00
:
0
5
:
1
E:3
4
:7
0
:
2
9