Dell EMC AX4-5 User Manual
Download Hardware installation and troubleshooting manual of Dell AX4-5 Storage for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Storage
Type: Hardware installation and troubleshooting manual
Model: Dell AX4-5 , Dell EMC AX4-5
Pages: 60 (0.96 Mb)
Download Dell AX4-5 Hardware installation and troubleshooting manual
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
30 Cabling Your Cluster Hardware
Cabling Multiple SAN-Attached Clusters to a Dell/EMC Storage System
To cable multiple clusters to the storage system, connect the cluster nodes to
the appropriate Fibre Channel switches and then connect the Fibre Channel
switches to the appropriate storage processors on the processor enclosure.
See the Dell Cluster Configuration Support Matrices located on the Dell High
Availability Clustering website at dell.com/ha for rules and guidelines for
SAN-attached clusters.
NOTE: The following procedure uses Figure 2-9 as an example for cabling
additional clusters.
Cabling Multiple SAN-Attached Clusters to the AX4-5 Storage System
1
In the first cluster, connect cluster node 1 to the SAN.
a
Connect a cable from HBA port 0 to Fibre Channel switch 0 (sw0).
b
Connect a cable from HBA port 1 to Fibre Channel switch 1 (sw1).
2
In the first cluster, repeat step 1 for each node.
3
For each additional cluster, repeat step 1 and step 2.
4
Connect the storage system to the SAN.
a
Connect a cable from Fibre Channel switch 0 (sw0) to SP-A
Fibre
port 0(first fibre port
).
b
Connect a cable from Fibre Channel switch 0 (sw0) to SP-B
Fibre
port 1(second fibre port
).
c
Connect a cable from Fibre Channel switch 1 (sw1) to SP-A
Fibre
port 1(second fibre port
).
d
Connect a cable from Fibre Channel switch 1 (sw1) to SP-B
Fibre
port 0(first fibre port
).
Connecting a PowerEdge Cluster to Multiple Storage Systems
You can increase your cluster storage capacity by attaching multiple storage
systems to your cluster using a redundant switch fabric. PowerEdge cluster
systems can support configurations with multiple storage units attached to
clustered servers. In this scenario, the MSCS software can fail over disk drives
in any cluster-attached shared storage array between the cluster nodes. When
attaching multiple storage systems with your cluster, the following rules apply:
• There is a maximum of four storage systems per cluster.