Delta 31-460 Instruction Manual

Download Instruction manual of Delta 31-460 Sander for Free or View it Online on All-Guides.com.

Brand: Delta

Category: Sander

Type: Instruction manual for Delta 31-460

Pages: 20 (1 Mb)

Download Delta 31-460 Instruction manual

Delta 31-460 Instruction manual - Page 1
1
Delta 31-460 Instruction manual - Page 2
2
Delta 31-460 Instruction manual - Page 3
3
Delta 31-460 Instruction manual - Page 4
4
Delta 31-460 Instruction manual - Page 5
5
Delta 31-460 Instruction manual - Page 6
6
Delta 31-460 Instruction manual - Page 7
7
Delta 31-460 Instruction manual - Page 8
8
Delta 31-460 Instruction manual - Page 9
9
Delta 31-460 Instruction manual - Page 10
10
Delta 31-460 Instruction manual - Page 11
11
Delta 31-460 Instruction manual - Page 12
12
Delta 31-460 Instruction manual - Page 13
13
Delta 31-460 Instruction manual - Page 14
14
Delta 31-460 Instruction manual - Page 15
15
Delta 31-460 Instruction manual - Page 16
16
Delta 31-460 Instruction manual - Page 17
17
Delta 31-460 Instruction manual - Page 18
18
Delta 31-460 Instruction manual - Page 19
19
Delta 31-460 Instruction manual - Page 20
20
16
Fig. 40
Fig. 41
Fig. 42
Fig. 43
REPLACING
SANDING BELT
1. DISCONNECT MACHINE FROM POWER SOURCE.
2. Remove screw (A) Fig. 40, and remove backstop (B).
3. Slide tension lever (C) Fig. 41, to the right to release
tension on sanding belt and remove sanding belt (D) from
both sanding drums, as shown.
4. Slide new sanding belt over both sanding drums
making sure the belt will run in the direction of the arrow
located on the inside of the belt.
5. Re-apply belt tension by sliding tension lever (C)
Fig. 41, to the left.
6. Replace backstop which was removed in STEP 2.
7. Connect electrical power to the sander and check to
see if the belt is tracking properly. If not, refer to the
section “TRACKING THE SANDING BELT”.
REPLACING
SANDING DISC
When it becomes necessary to replace the sanding disc,
proceed as follows:
1. DISCONNECT MACHINE FROM POWER SOURCE.
2. Loosen screw (A) Fig. 42, and remove table
assembly (B).
3. Remove three screws (C) Fig. 43, and lower cover
(D).
A
B
C
D
A
B
D
C