Delta 31-460 Instruction Manual

Download Instruction manual of Delta 31-460 Sander for Free or View it Online on All-Guides.com.

Brand: Delta

Category: Sander

Type: Instruction manual for Delta 31-460

Pages: 20 (1 Mb)

Download Delta 31-460 Instruction manual

Delta 31-460 Instruction manual - Page 1
1
Delta 31-460 Instruction manual - Page 2
2
Delta 31-460 Instruction manual - Page 3
3
Delta 31-460 Instruction manual - Page 4
4
Delta 31-460 Instruction manual - Page 5
5
Delta 31-460 Instruction manual - Page 6
6
Delta 31-460 Instruction manual - Page 7
7
Delta 31-460 Instruction manual - Page 8
8
Delta 31-460 Instruction manual - Page 9
9
Delta 31-460 Instruction manual - Page 10
10
Delta 31-460 Instruction manual - Page 11
11
Delta 31-460 Instruction manual - Page 12
12
Delta 31-460 Instruction manual - Page 13
13
Delta 31-460 Instruction manual - Page 14
14
Delta 31-460 Instruction manual - Page 15
15
Delta 31-460 Instruction manual - Page 16
16
Delta 31-460 Instruction manual - Page 17
17
Delta 31-460 Instruction manual - Page 18
18
Delta 31-460 Instruction manual - Page 19
19
Delta 31-460 Instruction manual - Page 20
20
9
Fig. 15
Fig. 16
Fig. 14
Fig. 13
ASSEMBLING DUST SPOUT
1. Fasten dust spout (A) Fig. 13, to sander base using
the three 3/8" (10mm) long pan head screws, two of
which are shown at (B), and flat washers supplied.
ASSEMBLING BACKSTOP
TO SANDING ARM
1. Assemble backstop (A) Fig. 14, to the sanding arm
using the 1/2" long hex head screw (B) and 5/16" flat
washer (C). Do not overtighten screw (B).
WARNING: TO AVOID TRAPPING THE WORK OR
FINGERS BETWEEN THE BACKSTOP AND SANDING
BELT, THE EDGE (D) OF THE BACKSTOP SHOULD BE
POSITIONED A MAXIMUM OF 1/16 INCH AWAY
FROM SANDING BELT (E).
FASTENING SANDER TO SUPPORTING SURFACE
1. If your sander is to be used in a permanent location,
it should be fastened securely to a firm supporting
surface, such as a stand or workbench using the four
holes, three of which are shown at (A) Fig. 15.
2. The diagram, shown in Fig. 16, illustrates the size
and center to center distance of the holes to be drilled in
the stand or workbench.
A
B
B
C
E
D
A
A
A