Delta SA446 Instruction Manual
Download Instruction manual of Delta SA446 Sander for Free or View it Online on All-Guides.com.
13
3. Alternately, you can secure the sander by fastening
it to a mounting board 18" x 24" or larger. The
diagram in Fig. 16 shows the size and center-to-
center distance of the holes that you will need to drill
in the mounting board.
NOTE: For proper stability, countersink the holes
underneath the mounting board so that the screw heads
are flush with bottom surface.
4. Securely clamp the mounting board to a stand or
workbench using 2 or more “‘C” clamps, as shown
in Fig. 17.
IMPORTANT:
If, during operation, the machine has a
tendency to tip over, slide, or walk on the supporting
surface, secure the machine base to the supporting
surface.
1. The on/off switch (A) Fig. 18 is located on the front
of the sander. To turn the machine “ON”, move
the switch up to the “ON” position.
2. To turn the machine “OFF”, move the switch (A)
down to the “OFF” position.
OPERATION
OPERATIONAL CONTROLS AND ADJUSTMENTS
Make sure that the switch is in the “OFF” position before plugging in the power cord. In the event of
a power failure, move the switch to the “OFF” position. An accidental start-up can cause injury.
A
STARTING AND STOPPING THE SANDER
Fig. 16
Fig. 17
Fig. 18
ll
l
l
18 MIN
5-1/2"
15-1/2"
24 MIN
3/8" DIAMETER
(4) HOLES